Greetings HPT Forum users, I'm wondering if anyone has a 400hp platinum ecoboost tune file I could use to compare/contrast with the standard 375hp tune. Any help is appreciated.
Steve
Type: Posts; User: stevewix
Greetings HPT Forum users, I'm wondering if anyone has a 400hp platinum ecoboost tune file I could use to compare/contrast with the standard 375hp tune. Any help is appreciated.
Steve
I'm wondering if anyone can upload their stock 392 Jeep tune file to the repository, or email me directly. Please PM for email address. Steve
I'm interested in locating the controls on a 2015 Jeep Wrangler that influence the behavior of PID 35084 and 35085. The pair are found in Engine>Airflow>Electronic Throttle>Pedal Power titled Power...
I'm presently checking into building a small turbo setup for my 2015 Jeep Wrangler Unlimited. Does anyone know the pressure capability/rating of the stock map sensor 5149174AB? Also stock injector...
It's fixed. The occasional code in 4hi was caused by the ultimate 60 front axle spindle nuts being loose. The 4lo error codes were caused by an incorrectly programmed t case ratio. The autel was...
I was able to confirm the gear ratio changed and tire size changes did in fact program correctly. I'm beginning to wonder if this isn't a torque management issue as Blue Bee mentioned above. I...
Were you able to resolve this issue? I just changed axles and am having the exact same issue (4.56 to 5.38 ratio change, no other codes). Mine only acts up in 4wd, especially low. If I go to...
I think I'm ready to say Nevermind. I just read up on the NN system. Got it!
Wow, thanks for the info on that! I'm going to have to read up on how to calc the tables that use g/cylinder in SD mode.
I just got my PCM back from being unlocked, and noticed right away in OL and CL the O2 voltages are around 3000. I drove it a few miles and the LTFT and STFT are populating, can anyone tell me what...
Would you be interested in sharing with me a rough idea of what these engines like regarding valve timing? I'm going in tomorrow to dyno tune and would like to build a file in advance.
hey guys, i've got bank 2 reading in the 885-895 range, and bank 1 in the 920+. i've got headers w/ory, fipk, magnecor, NGK tr55s, rear cat delete, and SD tune.
which bank is which? i'm assuming...
don't i just need the bosch 5-wire? if i'm plugging into hptuners, why do i need the specific controller box?
how does the sensor interface with hptuners?
ok guys, wtf with this HPtuners program?
i've come to the conclusion that i need a WB 02 sensor. what's the deal with these things? do i pull one narrowband out and replace with the wideband? do...
i helped chet with this tune, and the o2 sensors go choppy, really choppy once in a while during normal driving, and always during WOT.
please send me your email addresses, i can send you the scan...