Search:

Alvin,
Whats the availability on your harness?

If a swap harness is used does the segment swap still need to be performed?

looking for a tune for a 80e swap. segment swap . OS is 4073003. need one with a 80E to complete the swap. cannot find one.133616:banghead:

we will find out

you nailed it. reluctor wheel was on backwards. K1 technologies Crankshaft out of the box.

24X reluctor wheel was on backwards. K1 technologies Crankshaft out of the box.

that is what i am afraid of. when you had seen this before did it cause the coils not to see a signal to fire?

new crank? seen this before with crankshaft reluctor wheel being installed backwards or bent.

04 silverado SS. new build . engine will start and idle only. Cylinders 1,4,6 and 7 are not firing. Non DOD Engine. No signal to coil to fire. I have double checked coil grounds, ecm supplied ground...

Thanks for your thoughts blndsquirrel. Problem is there is no spark at these coils. The ecm is not sending the herz signal to fire the coils.

04 silverado SS. new build . engine will start and idle only. Cylinders 1,4,6 and 7 are not firing. Non DOD Engine. No signal to coil to fire. I have double checked coil grounds, ecm supplied ground...

Thanks man. I appreciate your help.

I have a case# opened with support and i sent the tune as well. THanks for the help.

74473

i recieved a mail order tune. tried to open file and recieved unable to open file. unsupported or newer version detected. update software. i installed version 3.6 and i still recieve the error. what...

throttle position sensor

65743

have a LS1. PCM come out of 2000 vette. has a 4l60E behind it. TPS Stays at 0% while pressing the accelerator. has drive by cable throttle body. what i am missing. turned all ETC to 0.

you ever find the cause of your issue? I am fighting a similar issue.

Looking on input from anyone that has had an issue with stabilitrack and active handling faults after procharger race BOV installation. We are running a procharger P1sc-1 procharger with a 3.50...

got it guys. thanks for the help. Had a issue with the usb driver.

Had to have my laptop restored. Installed version 3.0 off the website. when I try to connect and read the ecu I keep getting interface not found. I installed the latest version 3.0 from the hp tuner...

what is the email address to support?

Ken. I tried that. Worked great but i only had driver B. There was no a driver A.

when the device is plugged in it recognizes chanel b.