I did not have any issue with reading, but I was not able to write my tune to the NGC.
Type: Posts; User: mprmn3
I did not have any issue with reading, but I was not able to write my tune to the NGC.
So the problem was in my wiring, I built a bench harness and my problem went away. So I dove deeper into my wiring and found that I was getting a voltage on pin 30 of C1 (NGC3 Dodge) which is the...
Does it have to have a VSS hooked up? I am running a TKO2 with manual speedo pickup gear.
What did you end up finding to raise your RPM limit? I'm running into the same issue on my swap. Used an 06 Charger R/T 5.7 into a 73 Charger. Was a NAG1 and I put in a Tremec, but can't find a...
I have been trying to write to my NGC3 CAN from a 2006 Charger R/T in a stand alone setup. I get the Controller Init:Failed when I try to Write Calibration, but it reads fine and shows that it's...
Hey, would you mind sharing your 408 tune? I'm in process of gathering parts to stroke my 2001 5.9 and would like a little help with the factory JTEC+