Hallelujah!! You are the man! Jumper wire did exactly what you said sir. I found the bad ground...it was on the driver head. I must have ripped the wire out of the connector when I was fighting the...
Type: Posts; User: ragtopz28
Hallelujah!! You are the man! Jumper wire did exactly what you said sir. I found the bad ground...it was on the driver head. I must have ripped the wire out of the connector when I was fighting the...
Again pardon my 'electronical' abilities. The OB port has power. I'm not getting the jumper wire from PCM... Like, just a wire connected to good chassis ground and to the PCM where? I did check the...
I'm not the best when it comes to wiring. I have a couple of "wiring guru" friends but they are non-responsive atm. I agree with your theory of it not 'losing the tune' but was told otherwise by a...
Your timing is amazing. I just checked, and no check engine light comes on when key forward. I have a AEM? read all gauge that plugs into the OB port and it won't read either. I'll check grounds...
Thank you. Those first two were very helpful. This one....
My bad...it is a 1998 Pontiac TransAm Stock '98 computer working with no issues until powered back up.
Thank you,
Please bear with the newb here...
I am trying to load a new start-up tune. The port has power, all batteries charged, etc. When I go to write it appears to be "looking" for about 2 seconds the says...
Picked her up and so far shifts better than ever. Smooth, no surging or hard down shifts. Fingers crossed.
My dealer just called and they did the SB- replace with some new Mobile 1 fluid and replaced the harness and re-flash. I haven't picked it up yet but will report back. They said they did not need to...
I don't have an answer but my 2016 / 8 speed is doing the same thing. It is in the shop now for a flush and fill. It tripped code PO711 - fluid low, dirty, or sensor and code PO700 - shift solenoid...