Search:

Wondering if there will be support added for 2023 Commander 700's.

Nothing wrong with the cam, the phaser lockout leaves power on the table. VVT broadends the range of the cam.

What sticks out to you on the VVE? I thought it looked pretty decent. Maybe its off due to something else that is wrong that im dealing with now? What about "several other things"?

Hello everyone. I am almost at a loss on this one. Small background info, I own over 200 credits and have tuned a lot of prior Gen V stuff and have done some smaller Gen V jobs prior to this one just...

Alright folks, been trying to get converter in my ctsv to lock up solid when it goes to lock but I still get the tcc pressure ramping up and down with load and sometimes it hunts and I can feel it...

I figured it out. Just updated my vcm scanner. Works now.

Ok, so I was able to power up the ecm and connect to it. i repolled and it doesn?t show any of those parameters. May have to buy a newer ecm then?

I would buttt, then engine isn?t even in the car let alone the engine harness or ecm. Guess I could try and plug the ecm in and put some power to it maybe.

So a brief search revealed that my software version is an early 04 version possibly. I will need to try the repoll when I get the car running again here in a couple weeks, currently doing a major...

Ohhh, ok. I found it, I was looking in the wrong menu. It is 04510848AA

ngc3, t0reh180535jac

Really? Maybe my car has an 03 pcm then? Any numbers I could go off of to tell?

Hptuners doesn’t seem to care to fully support their “supported veicles” so good luck getting replied to. Would like to have the ability to log commanded afr, knock retard, and injector pulse width.

I am aware that your guide does have that step in it, however I did not utilize those settings. I did verify with the vcm scanner, ignition on engine off that the map sensor read 14.4 psi, right in...

Apologies, I stand corrected, thought I did read somewhere regarding the 2011 and later. The crank/no start is still boggling to me though.
As far as the tables being unlocked, im clueless as to...

Ok, so for the past few days I have been trying to increase the desired torque therefore increasing desired TIP on my friends 2012 Taurus SHO. Most of my experience comes from tuning GM's so I am...

Thank you very much!

I clicked the units at the top right just to see what units were available on my VE table and went from %, to ppm, and then blank and now my VE table looks like this. What to do?

69497

Will the NGC3 controller ever get knock retard pids in the VCM scanner?