thank you, i been trying to contact a2speed without any luck. i wanna send trx pcm to put jeep VIN and turn off SKYM.
how are they using that pcm in a gpec5 equipped vehicle?? they offer the...
Type: Posts; User: castorjames
thank you, i been trying to contact a2speed without any luck. i wanna send trx pcm to put jeep VIN and turn off SKYM.
how are they using that pcm in a gpec5 equipped vehicle?? they offer the...
hello any more info on this?
attached is a file from a 2020 jeep wrangler with demon swap.
it looks like it uses custom Operative system in both ECM and TCM??
any help in who can do this kind...
can you turn skym off and changue vin on a 2022-2023 trx pcm? currently working on a 2023 gladiator , installed a hellcat engine , any info on what other companies are doing for this swap? thanks
Hello, doing a hellcat engine/trans swap on a 2023 jeep mojave ..
Any one knows what ecm/tcm calibration to use?
I think a 2023 ram trx cal would be the way to go ? Any help would be apreciated
hello, did you wire?:
PIN: 3-----TN/WH-----Axle Switch Signal
Is There any special way to read/flash those ecm in bench harness? 2020 swap i can read it but cant flash it. Installed ecm in a normal truck and was able to read/write.. what Wires for vence harness...
it uses the stock throttle body. yes i did turn back to stock almost all throttle tables and driver demand tables because was testing the throttle oscilation and the WOT body lag without any succes....
throttle body start to oscillate when map goes 1-2 psi of boost at part throttle. also it takes some time until throttle body goes full open.
any help? thanks
yes, just wanted to start with magnuson file as base, already sent email to magnuson as per their instructions but didnt received it yet, i got this 2018 jeep magnuson file, it worked fine as base.
hello looking for magnuson provided calibration for 2020 jeep gladiator. thanks
i have worked with him many times before for remote tune service and other times just looking for help and hes been there. Gen V, ford and dodge.
i dont think this is the way to resolve your...
share please
hello, looking for a tune for a 21 ford 6.7l superduty, need it for today, pcm already unlocked. send me PM thanks
Go to :
ENGINE DIAG-------------AIRFLOW--------------------MAXMAP(45635)---------------set to 195kpa
this will prevent the map to read higher than 200kpa and will avoid the limiter.
how much...
who can share a picture of those tables? cant find em.
Three other directly related tables are under your torque model tab - they are airflow for high, low and mid altitudes - these will do the...
Thanks . Speed density calculator is treated like gm VVE? Need to pay attention if model goes weird when calculating the table? What others pids will help with fuel logging ? Thanks in advance
Thanks sultan. I'll shoot you a pm
Hello, what is the correct place to correct fueling on 2019 f150 trucks?, speed density calculator?? and what is the correct way to use it? thanks
Attached is the file of the car, it is a 2014 jeep with hellcat engine.
its setup with a 4l80e trans now.
What would be the best aproach here?
Do i need to changue in the tune for manual trans?...
make sure your swap has the correct high pressure sensor for your app. 3 pin vs 4 pin. double check the 2 connectors that goes behind intake. they can be mixed and will make this issue
set your gap to .019 and you will be golden.. i just tuned 1 of those, really close s etup. it started to blow spark at 10 psi with gap at .035
make sure you have the correct spark plugs, the ones...
Today ill teSt another truck. it haS the Same iSSue, weird to drive becauSe of the throttle body (it haS magnuSon Sc). ill Share reSultS, hope thiS make the trick again.
dizable torke converter in the tune; part throttle/wot. when you done then you can ztart tuning tcc to your like, how iz it zhifting at part throttle?
pleaze check your tranz oil level, overfill...
put your ztock tranz tune, mod your zhift zchedulez and RPM, up the tranzmizzion prezzure trezholdz, DO not reduce or remove tranz torke management, i can zee you lowered multiplierz on tranz torke...
truth[/quote]
x100