Or does someone have a C7 Automatic HPT file I can have a look at?
:)
Type: Posts; User: Crackerbuzz
Or does someone have a C7 Automatic HPT file I can have a look at?
:)
.
Hi all,
I am looking to do some tuning on my LSA Swap which has the 6L80/90E platform from a 2013 CTSV.
The original stock vehicle had the following transmission shift positions on the...
Thanks HJ, will grab a tune file in the next few days and post them up.
Cheers
Hi All,
Having an issue with my auto (LSA/6L90 - 3.54 ratio rear end), had some mods done to engine - higher boost (2.55 upper pulley - block hugger headers, 2.5 inch stainless exhausts, plus...
ok guys,
So we got the thing running really good.
The issue was that some of the codes were not actually turning off until you hovered over the RH side of the DTC and chose what ACTION to take...
Thanks BS, I will come back to you on this when I get a chance.
I don't have a diagram of the transmission TECHM wiring, but there is one spare set of Can wires available on the generic plug I...
Sorry... I meant U0100
Thanks HJ, I will look into this
Hi Blindsquirrel...
Thanks for the reply
Here is what we have (I have added the 120 ohm resistor at the DLC and we are reading 60 ohms across pin 6 and pin 14 on the OBD2)
Is there any need...
Hi again...
I also have another issue we are trying to resolve. (Speedo Output)
I am installing a paired combo of a 2013 LSA 6.2 supercharged and the 6L90E tranny that came from a 2013 CTS-V....
Hi all,
I am installing a paired combo of a 2013 LSA 6.2 supercharged and the 6L90E tranny that came from a 2013 CTS-V.
I am also running the factory harness that we have modified, but I am...
Cheers, I have calibrated IAT1 from a known source (E67 to LS7 MAF table)
Good call...
No one else have similar tune?
Are you getting any codes?
Thanks for that, very interesting
Hi All,
Finally got the MAF operational... I have started a new thread based on this.
Thanks for all comments
...
Hi All,
I have got my LS7 MAF + 100mm tube working well and now need to look at scaling it to the stock tuned 2013 CTSV E67 ECM.
(MAF CARD - GM Part#23256991)
Has anyone got a similar setup...
Hey Dhoag
Any chance of getting a copy/link of the GM GDS for this?
Hey 007 did this work for you?
Thanks
Thanks for that, That's what I thought. I find it strange that HPT does not have this in a user guide?
How did you go with dropping out the TCM?
Hi there,
Is there a "sticky" or manual which shows what each code type actualy means:
Eg
Permanent - No MIL and never goes away
Current ???
Pending???
Old ???
Thanks Jon,
That's good info. Yes we have seriously re-worked the harness so have probably mixed up a pin-out.
Cheers, we will work our way through this.