Hi Does anyone have a stock calibration file for a 2021 or 2022 GM truck they would like to share? I tried the tune repository and there is nothing that new on there. I just want to look at this...
Type: Posts; User: RACELS1
Hi Does anyone have a stock calibration file for a 2021 or 2022 GM truck they would like to share? I tried the tune repository and there is nothing that new on there. I just want to look at this...
Hi, Has any one else using GM Tis2web for programming blank ecm's found out that anything 2010 and newer(global A Architecture) can not be programmed off board? They must be in vehicle querrying...
Hi, Does anyone know how to show O2 and Cat monitors as completed? Wont go through emissions test. thanks.
Hi All, I would like to download a tune that has the fscm in it from the tune repository to look at. What year/make/model would i look for? I haven't done one of these yet and just want to see what...
Which box do you use to permently turn off a code? Mill off x cycles etc.
Oops, my bad, turns out you have to plug it in.
Hi All, my NGK-AFX will not read in 3.6. anyone else have this problem? I did remove it from channel config and reinstalled, still nothing. worked fine in 3.4. Thanks
Thank you.
Hi All, I can't figure out how to change the update rate on the chart vs. time. It's just creeps across the screen very very slowly. thanks.
I think I figured it out. I'll know in about 10 minutes.
Hi All, I'm using a NGK-AFR to log a/f. Works fine. I want to create a Lambda pid. I can't seem to figure out how to do this. Any help would be appreciated. Thanks.
Hi, anyone else having a problem with the scanner locking up in 3.04 and 3.05? Also having a problem with losing pids and chart setups when it locks up.
Ttt
That's it. thanks
Ttt
Hi All, I converted this tune to the 2bar SD OS. I'm just playing with idle and part throttle free revs. I can take 30% out of the ve table with absolutely no change in afr. I am logging VE_Lambda...
Hi All, I know i saw a post in here somewhere on how to set up a user defined pid using the 13500745 gm fuel psi sensor. I've searched and can't seem to find it. Any help would be appreciated. thanks.
Hi, I'm trying to make a boost pid for 2.24 scanner. It's a 01 F body 2 bar conversion. I've searched the forum but can't find anything. Any help would be aprreciated. thanks
I see. I won't ask when.........
okay. I can not find the eio screen. Is this supposed to be on the channel screen? I can't find a area to create a new eio, save config files to, or open a config file. Is there any links to working...
Hi, can someone point me to a tutorial on how to get my wideband and fuel psi configs from 2.24 to 2.25? Or how to recreate in 2.25. I'm sure its right in front of me, however i did tie my shoe laces...
You may need to perform a pcm to bcm relink using a tech2. I run into this alot with GTO's that have been sitting with dead battery's for a long period of time. I use the tech2 and have a...
Hi, I have a 06 GTO LS2 on the engine dyno with E40 pcm. I have the program running maf only to get that curve dialed in. Problem is about 4800 the maf hits 9300-9600hz and just sits there until the...
So if I'm understanding this correctly. even if I'm commanding and running at 13.5:1 my NGK/AFX display will still read 14.7:1?
IF your vehicle is completely STOCK, all you should have to do is change your pe tables to your desired afr. IF your vehicle is MODIFIED in any way you must recalibrate for your mods.