Keep Getting an error message Can not access vehicle diagnostic protocol. Anyone has any clues as to why I resynced and went through all the motions but still cant get it to connect Any help...
Type: Posts; User: Djc79
Keep Getting an error message Can not access vehicle diagnostic protocol. Anyone has any clues as to why I resynced and went through all the motions but still cant get it to connect Any help...
i replaced every vacuum line in the car. I ordered a diverter today so we will see. Appreciate the feed back. I did have the diverter out and was able to move it with my scan tool. but either...
I hope i attached that right. And yes i did a pressure test on the cold side and smoke tested the intake. All my sensors seem to be where they should be. Let me know if i uploaded the read...
Need some input guys.... I think i have a bad diverter valve. Im losing boost somewhere. I should be up over 30 psi but im not. My waste gate DC is maxed out With the cold air intake its...
I wanna do a boost leak test. Can i put pressure directly into the turbo inlet. Are there any lines that i have to remove? All the lines for the PCV system have check valves correct? If...
so is the system normally closed or open? I did get a leak code prior to the gas cap but havent got one since. I believe the car is bi polar. took two logs today and during the day she just dont...
My Ltft are or were extremely high. Maf was reading around 1300 htz. I just started isolating parts of the vacuum system. When I blocked off the EVAP system I was able to get my numbers somewhat...
quick question. Can a EVAP vent solenoid mess with your fuel trim if its not working correctly. So I believe the vent is naturally open. Mine is reading closed all the time. I can command it...
After a week of trying to get it to read my mpvi2+ I have finally got thru that part. When I attempted to do the first read I got this messaged
Failed to read ecm Controller unlocker x11...