Search:

Type: Posts; User: 09Vic

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. True... But I was still surprised. I worked at...

    True... But I was still surprised. I worked at the Saab dealer for a few years and really didn't think I had a chance.

    It was an epic battle of 14 second street cars.. :-)

    You did bring up an...
  2. Crown Vic vs. Saab 9.3 2.0T Aero (after a week and half of smack talking)

    So as the title says, after a week and a half of smack talking a co-worker and I finally had our chance to face off. I have a 100% stock Crown Vic (minus the tuning via HPTuners and my know nothing...
  3. Replies
    55
    Views
    1,190

    Thank you for fixing that. My bad. J06cvpi... ...

    Thank you for fixing that. My bad.

    J06cvpi... Who forced it to run in open loop?? I surely didn't.
  4. Replies
    55
    Views
    1,190

    Base.

    Base.
  5. Replies
    55
    Views
    1,190

    The only settings I saw for this are tcc apply...

    The only settings I saw for this are tcc apply speed in relation to the tps%.

    Not sure if thats the right one or not. Have to wait for another reply.
  6. Replies
    55
    Views
    1,190

    The trans stuff I'm not sure about. Best to wait...

    The trans stuff I'm not sure about. Best to wait for a reply from someone more knowledgeable.
  7. Replies
    55
    Views
    1,190

    No pt2 still wont be right. Once you get things...

    No pt2 still wont be right. Once you get things fixed we can go through editing the tune you have now. The tune you have has some other adjustments done to it that the last one doesn't. You can do a...
  8. Replies
    55
    Views
    1,190

    Ok... I dropped your timing so it hopefully...

    Ok...

    I dropped your timing so it hopefully maxes out around 20. Running 93 and cat problems this is your best bet. I also tried to quicken your open loop fuel enrichment. It may take a couple...
  9. Replies
    55
    Views
    1,190

    Your power enrichment isn't kicking in. Do you...

    Your power enrichment isn't kicking in. Do you have any o2 sensor codes or anything?

    Basically under wot you should be getting more fuel than you are. But that's not happening so your getting...
  10. Ok.... I didn't go nuts as I am not sure what...

    Ok.... I didn't go nuts as I am not sure what fuel your burning etc.. Also I'm not sure what your going for.

    So I fixed your stoich values due to almost all pump gas being at least e-10

    Also...
  11. Replies
    55
    Views
    1,190

    When load increases it adds a bit of spark to...

    When load increases it adds a bit of spark to help with throttle response.

    You basically don't need it with your current timing adjustments.
  12. Curious what your rpm is at 70mph. I wanted to...

    Curious what your rpm is at 70mph. I wanted to swap to 3.73 right after I bought mine so that's why I ask.

    Post your stock tune file. And what octane fuel your currently running.
  13. Replies
    55
    Views
    1,190

    Well being that its working we can add a little...

    Well being that its working we can add a little timing up top and see how it goes. I like to make small incremental changes to one or two things at a time and make sure they work before doing...
  14. Replies
    55
    Views
    1,190

    No worries. Take your time.

    No worries. Take your time.
  15. Replies
    55
    Views
    1,190

    Ok I made a couple changes. One to your stoich...

    Ok I made a couple changes. One to your stoich values as I am sure the fuel you are using is probably a e-10 blend. So I changed it to reflect that.
    Also your load increase correction was a touch...
  16. Replies
    55
    Views
    1,190

    I'll look at a few things.. Gimmie some time.

    I'll look at a few things.. Gimmie some time.
  17. Replies
    55
    Views
    1,190

    I can help with what I know which honestly isn't...

    I can help with what I know which honestly isn't much.

    I know to leave the MBT alone. Adjust the borderline knock table but DO NOT exceed the values in the MBT table when your changing things. The...
  18. Replies
    3
    Views
    148

    Indeed... Its a long log file. Around 10:59 in...

    Indeed...

    Its a long log file. Around 10:59 in the log is where it shows.




    Thank you. I thought it was more like a old school accelerator pump setting but I had to ask to be sure.
  19. Replies
    3
    Views
    148

    Transient Fuel Gain Questions.

    The car is a 09 crown vic 4.6 2v with the spanish oak ecm

    In Engine > Fuel > Transient

    I have tables for Gain, Gain at start up, Time constant, and Time constant at start up.

    My issue is it...
  20. Thread: I?m new hi guys!

    by 09Vic
    Replies
    4
    Views
    167

    Search threads with my user name. I got help...

    Search threads with my user name. I got help earlier for my car. A simple thing to remember is don't add lots of timing for low octane fuel. Make small adjustments and don't make a lot of adjustments...
  21. Replies
    17
    Views
    555

    Lololol. Man I must've been tired. Disregard...

    Lololol. Man I must've been tired. Disregard the post above this one..
  22. Replies
    17
    Views
    555

    Ok one last question... I apparently don't...

    Ok one last question...

    I apparently don't have any open loop fuel tables to adjust. So I'm stuck modifying stoich to get a target WOT (open loop) fuel ratio. So is this a workable option if I...
  23. Replies
    17
    Views
    555

    Thanks for the input guys! Ran it today....

    Thanks for the input guys!

    Ran it today. Gained about 23 ft lbs of torque over my previous log file so that's great!! It runs really well, very smooth. Gained about 5 degrees of timing. (4.8) at...
  24. Replies
    17
    Views
    555

    I've checked it a few times it seems to vary...

    I've checked it a few times it seems to vary depending on the seasons. It's on average around the 70% range. I've got to get a new tester, broke the old one and haven't checked in a while.

    ...
  25. Replies
    17
    Views
    555

    Thank you for taking the time. I see you changed...

    Thank you for taking the time. I see you changed quite a few things. I'll do more research on those so I can better understand. I'll give it a try soon and let you know.

    BTW I run exclusively e-85...
Results 1 to 25 of 38
Page 1 of 2 1 2