As a side note, i loaded my sd tune in yesterday, and when not in blended or maf only, the car locks as it should. Only difference in tunes is maf re enabled, ltft turned back on, and dfco turned...
Type: Posts; User: cfry
As a side note, i loaded my sd tune in yesterday, and when not in blended or maf only, the car locks as it should. Only difference in tunes is maf re enabled, ltft turned back on, and dfco turned...
Hey guys. I installed an SS3 VVT Cam from a BTR stage 2 3 bolt, and have had problems with my shift points and lockup ever since. I have tried to hunt the problem. I am seeing low misfire...
I usually drive for about 5-10 minutes. That will be a starting point. For reference on how things should kind of look like, this is an auto car so ignore the trans stuff, but it has a BTR stage 2...
yes, add it to channels. I cant help correct any fueling without seeing where the issues are. But seriously. I would check the passenger bank of the motor to see if it is an O2 problem or if you...
Not sure where to start here. Are you trying to fix the tune, or fix the fueling? The spark table is a mess. The PE is so far off it is not even funny. Does the car have cats on it? You need to...
I cannot download your attachments. Was going to look at it, but have no way to do so. Don't know if it is just me or if anyone else has been able to.
Could you post a little more about your runs? 330 660 1/8Times, mph, and also post your tune? What fuel are you using? Tr7 seems like too cold a plug as well... what was the DA on your run? Also,...
If you look at the Cylinder air mass, you are not getting over about .72-.76. At 6k RPM, you are commanding about 24 degrees of timing. You are then adding somewhere with a multiplier as stated. ...
Log a fuel cut type pid. If it isay immob, then vats is not disabled. I would start there.
I'm not sure I understand what you mean by it cannot mechanically handle the downshift. Could you elaborate?
Anyone have any thoughts?
72817Here is an example with type of torque management. Both are in the Trans. I also pulled my max burst down to 4 degrees.
Attached a smaller file of the event.72797
Hello guys.
Here is my platform:
2010 Camaro A6 with LS3 conversion. BTR Stage 2 and a 3200 Stall. 3.73 gears.
I am working on my tune, and have developed a hiccup on a 6-3 or 6-2...
Thanks Gilgamesh. I saw similar, but did not see this one. Will say that I am glad they will take care of it, but am a little down on the timeline, and the fact that this seems to be a repeatable...
Wrote a support ticket, but am curious to get feedback here also. I installed new software, hooked up to a vehicle, selected read, and was told some features may not be available without an update....