Search:

Type: Posts; User: mtb703

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    3,170

    If your recirculation valve is staying closed,...

    If your recirculation valve is staying closed, you are essentially moving as much air as mechanically possible. Only improvements from there are to your intake setup. Log ambient and the pre...
  2. Replies
    59
    Views
    16,997

    ~200 kpa is going to be around the max you...

    ~200 kpa is going to be around the max you without a pulley swap.
  3. Replies
    59
    Views
    16,997

    That's the 3rd MAP sensor. The MAF is a...

    That's the 3rd MAP sensor. The MAF is a calculated value, derived from manifold pressure. Its used to verify some other low level logic, Germans have a ton of system checks and verifications going...
  4. Thread: Audi S4 3.0T

    by mtb703
    Replies
    8
    Views
    2,674

    Last I looked, HP Tuners was missing a few needed...

    Last I looked, HP Tuners was missing a few needed tables, I ended up using WINOLS. Additionally, are you M6 or DL501? The DL501 has an overriding torque limit that you need to bump up, along with...
  5. Replies
    4
    Views
    1,329

    I would think user defined parameters should be...

    I would think user defined parameters should be able to do it.

    Create an XDF for it in TunerPro assuming you know the memory location.
  6. Replies
    5
    Views
    1,780

    Okay, what I don't get is that most (all) of the...

    Okay, what I don't get is that most (all) of the load axis uses an air mass mg/stk with a max of 1389, its setup like there is a MAF, but there is no MAF. SIMOS 8.4/8.5 does have the functionality...
  7. Replies
    5
    Views
    1,780

    Right, hopefully. And I thought about this map...

    Right, hopefully.

    And I thought about this map some more, its just a compressor map and should stay fixed regardless of what VE improvements happen downstream. Although I'd like to know what...
  8. Replies
    40
    Views
    15,846

    I'm pretty certain the the "stratified" mode is...

    I'm pretty certain the the "stratified" mode is only used during lean combustion.
  9. Replies
    5
    Views
    1,780

    Was this too remedial of a question? Kinda like...

    Was this too remedial of a question? Kinda like "if you don't know the answer you should probably take a step back"? lol
  10. Replies
    5
    Views
    1,780

    Simos 8.4 / 3.0t VE question

    Hi all, I'm trying to get my head around the workflow here, and I think I've got it pretty well figured out. I'm currently on a off-the-shelf 034 tune, but would like to try this myself come Spring....
  11. Replies
    29
    Views
    15,487

    ...

    ...
Results 1 to 11 of 11