Search:

Type: Posts; User: ScottTX

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    2,301

    Got it to finally work....re-polled parameters.

    Got it to finally work....re-polled parameters.
  2. Replies
    1
    Views
    2,301

    Lost status from trans channels

    I used to be able to see PRNDL status, current gear, and shift mode but now I get nothing on these channels while scanning, just blanks. I can write calibrate to trans so I know the communications...
  3. Replies
    0
    Views
    1,979

    Support for 16+ 3.0L Diesel?

    There is support for the 2014-2016 Range Rover 3.0L V-6 and 5.0L V-8, but what about the diesel variant? Are they not he same ECM controller?
  4. I had a similar problem. I opened a support...

    I had a similar problem. I opened a support ticket with HP tuners and they fixed it. Basically, I was asked to download the newest beta version of the software and it worked again. I don't know...
  5. Configuring Pin 57 for "higher pulse rate" for aftermarket speedo

    Any help is appreciated...

    Here are my speedo parameters. I can get a signal to my speedo if I set to Serial but it will not properly decelerate to zero. It will decelerate very slowly compared to...
  6. No one, nothing? I am going to have to rip my...

    No one, nothing? I am going to have to rip my dash apart to send this back to Speedhut which I would very much not like to do. If you have any thoughts, please share.
  7. Another E38 aftermarket speedometer question

    I have searched and searched for the answer to this problem on my own but now I need your help.

    I have a Speedhut speedometer that I am trying to get to work correctly with my transplanted...
  8. Configuring Pin 57 for speedo, need "higher pulse signal"!!

    Any help is appreciated...

    Here are my speedo parameters. I can get a signal to my Speedhut speedo if I set to Serial but it will not properly decelerate to zero. It will decelerate very slowly...
  9. Replies
    2
    Views
    1,166

    I did! It looks like one file the way the...

    I did! It looks like one file the way the attachments are loaded but its actually two. The tune "Original w TM.hpt" and the log "205323400410.hpl". Maybe I will see if I can add some space between....
  10. Replies
    2
    Views
    1,166

    Still downshifting at full stop, log review

    Be gentle...first post and still learning tuning.

    I have a tune (that I paid for), which feels decent on the engine (2011 5.3) side but it leaves a lot to be desired on the transmission (6L80e)...
  11. WRONG FORUM: Still downshifting at full stop, log review

    DISREGARD WRONG FORUM

    Be gentle...first post and still learning tuning.

    I have a tune (that I paid for), which feels decent on the engine side but it leaves a lot to be desired on the...
  12. Replies
    2
    Views
    3,680

    First off, I am no expert but what you said here...

    First off, I am no expert but what you said here "My assumption is it ran the OEM 2009 speedometer, and the output ive been given from harness rework guys was added in and comes from ECM??" is...
Results 1 to 12 of 13