I have to say this new scanner is a real pita. The old versions worked quite easily. I have spent well over an hour maybe two today trying to figure something out that just worked with older version....
Type: Posts; User: dllhg
I have to say this new scanner is a real pita. The old versions worked quite easily. I have spent well over an hour maybe two today trying to figure something out that just worked with older version....
Major issue seems to be pulling timing due to high IATs.
I just spent my entire Sunday reading about these blowers and ways to lower IATs. So the blowers are basically the same thing as the...
Here is one of my scans. 0-100 followed by a quick 60-90.
Would someone please take a look at my transmission settings. I am pretty sure they are very conservative. Would really appreciate any advice you can give.
Thank you
Been years since I messed with tuning and could use some help here please. I'm a little rusty ....
Car is a 2012 C6 LS3 Corvette with Long tube headers, Eforce 599 kit, upgraded injectors and...
Okay I figured it out. You have to click scan. Then click to stop scan. Then click to check for DTCs. Previous version you had to click scan then check for DTC. Not stop scanning.
Funny because 2.24 was exactly the opposite. Had to click scan to show readiness.....
I did that but none of the readiness status show up at all.
If its not removed then where is it ? Have to contact support for what should apparently be an easy answer ? :shrug:
I can no longer see readiness status of smog monitors in scanner. Shows DTCs and says readiness but doesnt show any of them. Talked to my tuner and he said the new 3.0 doesn't have this. I no...