Search:

Type: Posts; User: [email protected]

Search: Search took 0.00 seconds.

  1. o2 sensor? try to swap them

    o2 sensor? try to swap them
  2. I havn't any leaks. If there will be leak, trims...

    I havn't any leaks. If there will be leak, trims should go to + instead of -. Everything works fine but I tried to disable throttle adaption and it makes trims go crazy. Even if I correct VE tables...
  3. 5.7 NGC4 Electric Throttle Body-> Adaption, When disabled Fuel trims goes crazy low

    Why disable Adaption for throtle body makes LTFT and STFT for both banks goes to up -30%. I've tried to decrease VE tables but it doesn't help. When I set Adaption to Enable with decreased VE tables...
  4. NAG1 TCC slip cannot be set below 15rpm

    I've tried multiple solutions but Desired TCC Slip is always set to 15rpm and can't be lowered. I even set TCC apply /release to all gears except 1st to 0 and still desired slip stays at 15rpm no less
  5. WOT - Throttle body voltage decrase above 5500RPM and goes crazy rich at 3/4/5 gear

    Hi,
    I have problem with strange behavior during WOT. I found that TPS voltage drops always above 5500RPM (shifts are set to ~6050).
    Also why my commanded afr goes to 10.7:1 at 3rd gear and above?...
  6. It's not the case. I also found that few...

    It's not the case. I also found that few parameters dissappeared even with Advanced box is checked.
  7. o2 sensor General group dissapeared

    Hi,
    After update VCM Suite to newest beta it seems that few parameters just dissapeared, for example I couldn't Enable/Disable o2 sensors dor mopar cars. TO do so I need to use older version of...
  8. Replies
    3
    Views
    2,440

    NAG1 manual stick

    Hi,
    I had predator and when I choosed mode 1 in manual shift mode I was able to select each gear. When I switched to manual selector at stop I've seen [1] and it stays at 1st till I pushed lever to...
  9. Replies
    0
    Views
    1,084

    Slow VCM suite readings

    I have a problem with huge time intervals between readings. Sometimes it exceeds 1s. I've tried to remove PIDs, increase polling Interval but I've was able to only get 100ms with only 3 PIDs. It is...
  10. sorry for delay. I drived my car today since I...

    sorry for delay. I drived my car today since I don't use it till is unneccessary. So here is my Log. For me it seems that there is something odd with timing advance. At 16:59:20 my car stalls again....
  11. Replies
    48
    Views
    18,923

    @Bullet300 how about older hemis? Should I drop...

    @Bullet300 how about older hemis? Should I drop in advance table just in the same range as you did in that tune or should I extend range of drop off? By that I mean that uploaded tune spark tables...
  12. Diablosport 93oct equivalent tune for 5.7 '06 hemi

    Looking for tune equivalent for 93 octane tune from predator or better hpt tune pulled out from car with predator tune. It may be cai tune too
  13. So this is my current "tune". It is almost stock,...

    So this is my current "tune". It is almost stock, only like I said before, I've disabled few things. I've also need to "disable" TCC cause I have shudder issues. Long story short: I've experience...
  14. Which tune? From predator or mpvi? Currently I...

    Which tune? From predator or mpvi? Currently I have just stock tune with simply disabled flags for EGR, MDS and secondary o2 sensors. About datalog which PIDs you're interested? I don't even know...
  15. Ps. It is possible to change PCM from donor and...

    Ps. It is possible to change PCM from donor and adapt it with mpvi2?
  16. 300c 5.7 stalls after flash with mpvi2

    Hello,
    I have 5.7 hemi wagon. Previously I have predator with 93 oct tune + disabled egr, mds, shift firmness increase. I sold it because of lack of options. I've found that when I unmarried it...
Results 1 to 16 of 16