Search:

Hoping to find a stock file for a ram 5.7 that is or close to 2022. Bonus points if an e-torque truck.

Most recent in the repo is 2015.

Thanks

Thanks for the perspective. This was very helpful, especially if I think of the NN VE tables and trainer as simply just a set of reference tables that are looked up based on where the actual cams...

Is there a simple way to adjust so that the downshifts happen sooner, with less pedal? I see OSS and also see an axis with pedal %, but feel like I tried the pedal % but didn't respond how I...

What is really going on under the covers of the trainer??

As an experiment, I set all my intake cam position to a single value across the entire table, and did the same for the exhaust.

Then in...

Thank you for that detail. So per your comments it sounds like the short answer is yes, it does reduce actual fuel pressure at the lower end of the table.

Does this Desired Fuel Pressure table do anything on non-hellcat models?

108858

Not really what I was asking, but thanks anyway.

Yes, but use it for what all exactly?

With NN off, is the speed density VE table considered at all when the car is making torque, aircharge, or any other calculation? Does it affect anything other than simply fueling?

2017 charger

This is really interesting.

I have a supercharged 3.6 that has a very annoying stutter at part throttle under load when using the larger injectors that come with the kit. The strange thing is...

@hemituna Thank you for your detailed information sharing on this thread. I've read it at least 10 times and have seen good results as I continue to experiment with the airflow and demand tables. ...

What is trans max mode and what does it do?

I have a few spots in my log where the 'Actual Torque' exceeds that 'Trans Engine Torque' by more than a few pounds and the car flatlines for that moment. Where should I be looking/adjusting to...

DAVECS2,

Any luck with this yet? I'm finding from talking to folks that this is a pretty common issue. I have a supercharged charger that does this like a light switch in the same kPa/map range....

So, adding the timing to the base table helped quite a bit. Not quite perfect, but at least I finally found something that makes a difference.

2 questions still trying to figure out:
- How is...

Thanks trapper.

Yes, I did try the MAX FW tables. Which indicated tq tables are you referring to?

Also, this morning I was looking at part throttle base timing tables and they actually do...

Attached is the tune, the log was too big to post (18 Meg) so I shared it at the OneDrive Link below.

Observations:
- Since adding the larger injectors, logged Air Charge is about 100-200 mg...

3.6 with bigger injectors...the only mod, but seems to be enough to make the engine calculate a bit more torque at cruise and part throttle areas and is causing it to hit what appears to be a torque...

Does anyone know how the following is calculated:

Calculated Engine Load (SAE)
Absolute Load (SAE)

Also, how does the ECU calculate torque, and is there any variable in that formula that could...

I'm chasing a stumble around 2500 +/- RPM and 95 kPa. It is consistently reproducible with cruise control at a grade on the same hwy. It also happens at part throttle acceleration around the same...