Search:

I vaguely recall reading a post of someone with an 03 that had a pin in the wrong spot in the OBD2 port. Probably not the case since you're able to log but it's a thought

I just wanted to give a huge shout out to JimP. I was basically going to give up on the user defined parameters to accomplish some things on my 2012 cm2200. I thought I was going to have to go buy a...

Pm sent

I had a ticket with hpt support for this same issue about 3 months ago and ran into a dead end. They came back with, "I spoke with an engineer and it is not possible to get those channels on the...

Looking forward to seeing the calculator axis swapped for hpt. Doing it in Excel really stinks! Have a great weekend guys.

Yeah. I have to keep reminding myself the eq is inverse and will change when I am not tuning an n/a motor. Thanks!

Hey guys. This is the first time I've actually attempted to sit down and learn the software and basics. I have spent lots of time...lots reading and figuring out this stuff out to eventually be...

i have been logging through the isspro sensors and it works great. you really appreciate not having to look at the gauges instead of the road and trying to remember everything. seeing actual boost is...

https://www.isspro.com/TROUBLESHOOTING%20DOC/ISSPRO_EV2_Troubleshooting.pdf has the tables of pressure/volts and temp/volts if your sensor is different and you know how to do y=mx+b slopes and math.

I got it figured out!!!!!!!!!! anyone with hpt pro that has the isspro pressure/temp sensors. the formulas for the additional inputs can be derived from the info on isspros website about volts/temp...

oh, and they are both 120psi isspro ev2 units thanks.

hey guys i have hpt pro version and see that the plx box is listed in hpt for aux input settings to datalog. i was wondering how hard it would be to run my 5v signal wires from the isspro sensors for...

just an update for support and everyone else. if the above kit is installed, you can get the ecm to recognize the 2nd wif sensor with the b20 enable in hptuners and the dash light will go off. now...

i havent hooked up my exhaust backpressure gauge yet and just got a new cummins 1.25mm headgasket after the shitty felpro failed with arp 425 studs. what do you think i should keep drive pressure...

i just installed a mopar severe duty filtration kit on a 04 and was reading the install instructions and was thinking the aux wif sensor enable is labeled as the wif b20 in hptuners can anyone...

63/68/14 .80ar non gated housing until i put twins on her. and fueling with 50hp bms injectors. thanks

hey guys just wondering what would be a good safe number as a max rpm on stock bottom end on a 04.5 with fluidamper, 110lb springs, hd pushrods, headstuds. its my daily driver and tow rig that pulls...