Is there any possibility we could get Range Rover Evoque support?
Thanks
Type: Posts; User: Dhmoto111
Is there any possibility we could get Range Rover Evoque support?
Thanks
Check 1 more for 7.3
here is some info from www.ls2.com
http://www.ls2.com/forums/showthread.php?s=&threadid=17992
Those of you with a new motor/ old tranny combo what did you use for a VSS ?
Are there any that will fit?
i would like to run one and just wonder what everyone else has used
i specifically...
ok thanks its working now
When ever i click on the bin repository link i get promter for a pw did they change it to where you have to have a PW?
well according to the vin its an 01 and it definatly has a ETC
ive got an 01 5.3l from a tahoe i want to put a cable actuated throttle on it
what do i need to do in terms of the computer to make this change?
can i make the necissary changes in the computer with hptuners by writing an 01 fbody file to it? or do i need to get it reflashed with a techII?
i guess you cant vote anymore
does it have an ls1 in it? or you just saying that like ls1=genIII?
thats fine as long as its plugged into the front harness
i always use the rear o2's for LT installs because the wires are longer on the rear sensors
well i went ahead and got another tac module because im running out of time fast
would no tps signal cause it to idle so poorly like that? it makes sense to me. the throttle blade just stays...
72 international scout II 01 5.3L I havent decided if i will mod the motor or not other than Long tubes
mods in sig
i have a few problems here
im just now getting the 5.3L going...(out of an 01 tahoe)
to start i am throwing a p1518 code(electronic throttle module to pcm comunication)
All the wires are...
well after a few more trys it worked
i am having trouble with the vats
all i found from a search was to go to -system-general-vats-" none " Is this correct?
i tried that and when i rewrite it goes down the list saying "complete"...
i am having trouble with the vats
all i found from a search was to go to -system-general-vats-" none " Is this correct?
i tried that and when i rewrite it goes down the list saying "complete"...
i have a 72 scout and i just put a 5.3L out of a 01' tahoe in it.
the motor is almost completly stock, the only things that are different are that i have a cone filter instead of an air box and...
lol:doh:
where did you say that?
your throttle position will be different than everyone elses unless they have the exact same set up, as well as the same conditions including density altitude
if you have a higher numerical gear the drive shaft will have to turn more times for the same amount of tire rotation, resulting in a higher engine rpm. you would more than likely know if it had...
that you have different rear gears than stock
ok great
i need it right now so i can disable the vats in a conversion motor, just want to make sure i can still use it when i get home
im about to purchase the software
and need to know if i can install it on a computer(pc) and use it then put it on a different pc to continue to use it. will it allow me to do this?
sorry...