Search:

Type: Posts; User: Ranger Coyote

Page 1 of 8 1 2 3 4

Search: Search took 0.00 seconds.

  1. I have been dealing with correcting the map/maf...

    I have been dealing with correcting the map/maf sensor ratio on a supercharged mustang and it all comes down to the expected throttle angle vs actual angle and effective area. I have a tuning guide...
  2. I can give you examples that I used.. I had to...

    I can give you examples that I used.. I had to make extensive modifications to my air model to make my car run right... Look up Murfie, everything he says is gold man... He's good
  3. if you have even a slight vac leak it will mess...

    if you have even a slight vac leak it will mess up the predicted throttle angle and effective area tables, can you do a sanity check and make sure that your ETC vac + manifold pressure = barometric...
  4. 2016 Mustang - 727hp Roush PD setup with a stock strategy - what did I do wrong

    I have been searching for all Murfies posts and I have used everything he said to tune my car. What have I done wrong, tell me what to log and i'll post a log.

    113456

    the tune file:
    113457
    ...
  5. View Change/History Logs dialog box will not display

    I recently updated the VCM Suite and many of my files will no longer allow me access to the Change Log. I have an example file to look at below:

    This file does not work after an edit:
    112473
    ...
  6. Got my car all tricked out with 12.5:1 forged...

    Got my car all tricked out with 12.5:1 forged pistons, forged rods, forged 302 crank, all forged internals, billet oil pump, DSS driveshaft, DSS half shafts, blow fish ds loop, id1050x injectors,...
  7. I have my car back from Pinnacle Performace in...

    I have my car back from Pinnacle Performace in Owasso, OK. Runs fine now, cost me $1600 this go... It needed guides as expected and with labor, parts, gaskets etc it was just shy of $1600 for the...
  8. are you getting drive mode not available message...

    are you getting drive mode not available message as it enters limp?
  9. Replies
    2
    Views
    1,076

    if it's a 4x4 be careful pulling the fuse for a...

    if it's a 4x4 be careful pulling the fuse for a long term solution. If the 4x4 kicks in with no abs won't it be bad in some situations like if your tires are not going the same RPM?
  10. It has 38k miles total. I bought it brand new...

    It has 38k miles total. I bought it brand new and had the dealership install the 727 Roush kit at 2k miles. I am the only owner and I have changed the oil every 3-4k miles. I had billet oil pump...
  11. Knocking noise from driver side area - 2016 GT

    My car developed a knock at 38k miles. I suspected phasers but once the front cover was removed the problem became obvious with worn guides for the timing chain. Is there anything I could have done...
  12. Replies
    2
    Views
    905

    ID1050x

    You should be able to use the data Injector Dynamics provides. Did you already try this and it's not working?

    109632
  13. Best tune in the world

    I have a 2016 GT w/ Roush 727 kit and with the only engine changes being ID1050X, Return Style, no cats. You can try my street tune, it's the stock strat (NOT ROUSH)with a 6R80. The speed density...
  14. Replies
    88
    Views
    22,520

    Spark Delta Limiting Function [ECM] 45323 -...

    Spark Delta Limiting Function

    [ECM] 45323 - Knock Sensor SDLF Average Mode: Determines the mode for spark delta limiting function reference average. 0=Middle Values, 1=Minimum Values, 2=Maximum...
  15. Replies
    88
    Views
    22,520

    When I bought my 727HP Roush kit they voided...

    When I bought my 727HP Roush kit they voided parts of my cars warranty but the phase 1 kit only difference was no boost a pump and a bigger pulley and you could keep the warranty. If they let you...
  16. Replies
    2
    Views
    1,865

    FAOSC with no cats?

    I found a document from ford that said the faosc doesn't even come into the equation until you are 16% off stoich.

    1. Since I have no cats on my car does the FAOSC even work?
    2. Should it...
  17. Replies
    88
    Views
    22,520

    I love this thread... All the best guys on...

    I love this thread... All the best guys on HPTuners picking apart a "perfect" ford tune... Who knew it would be so fun to look over logs from an unmodified car?
  18. Replies
    88
    Views
    22,520

    I just got brand new id 1050x and they are not...

    I just got brand new id 1050x and they are not showing good results.. my ID1000 were better
  19. Replies
    3
    Views
    912

    You can add credits later very easily if you find...

    You can add credits later very easily if you find you don't get enough. You probably need two credits to start out. I ended up using 4 credits because I licensed a strategy I didn't have with a...
  20. You are correct in all your assumptions. If you...

    You are correct in all your assumptions. If you were to want to use one of the tables you mentioned, you must edit the axis values to have realistic rpm ranges
  21. Replies
    88
    Views
    22,520

    It looks like the valves are doing a pretty good...

    It looks like the valves are doing a pretty good job of following the optimum power valve settings.

    108833

    If you want to split hairs you could raise the low slope and high slope a tad...
    ...
  22. Replies
    9
    Views
    1,465

    can you hear any air sucking noises under the...

    can you hear any air sucking noises under the hood? I know it's hard to hear but it seems like a vacuum leak could be something to look for. I can't imagine your fuel to be that far off with just a...
  23. Replies
    5
    Views
    1,526

    There is another thread going on with some...

    There is another thread going on with some problems you might read... Looks like bad news: https://forum.hptuners.com/showthread.php?75763-EEC-V-and-VCM-Scanner
  24. Replies
    6
    Views
    1,112

    I'm not sure if there are limiters in the trans...

    I'm not sure if there are limiters in the trans that you can't access. There is a fuel cutoff under Fuel - Cutoff, DFCO, change the Cutoff RPM, Temp RPM and ETC RPM, I usually change the MAF fail...
  25. Replies
    6
    Views
    1,112

    Helps a bunch to have the tune, thanks for...

    Helps a bunch to have the tune, thanks for posting. Yours will use the "Borderline Knock" table as your base spark, it uses the MBT table as an upper limit and the Cylinder Pressure is the absolute...
Results 1 to 25 of 196
Page 1 of 8 1 2 3 4