Hello everyone. I have a jeep wj 2004 4.7 pcm JTEC+. I turn off p0443 and p0136 p0158, the MIL lamp is off, but there are errors when reading with a scanner. What can be done about it?
Type: Posts; User: 88nec
Hello everyone. I have a jeep wj 2004 4.7 pcm JTEC+. I turn off p0443 and p0136 p0158, the MIL lamp is off, but there are errors when reading with a scanner. What can be done about it?
thank you for your work. Can I use these tables without the involvement of the NN network?
share the firmware
I used this guy's technology. it helped me a lot. Thanks for the advice.
I turned off the oxygen sensor control and the NN network.
I share the firmware and record the log. In some loads, the...
i need vin code
116524
116525
I have a stock setup. the engine runs on it very richly.
I ran into a problem while editing VE tables. When you try to decrease or add fuel, there is no reaction to the action. If the cell has gone...
Are all the pulleys native? I ran into a problem, the profile of the stream was too sharp. On 6.2, the belt goes green after all, reinforced.
Does the pulley clutch work exactly? Bearings in the...
I understood you. Thank you. I tried to enrich the mixture using the AFR sensor, but reached 300% in some cells in the VE table, and realized that it was useless, nothing really changed. Problem with...
how did you understand that there is no PE mode? right now installed 2.9 volts on the pedal.
Desired mix in log 10.5 afr or 0.75 lambda. The injection time is 11.6ms, but this is still not enough...
a whistling sound would be heard if the belt slipped. If the compressor roller slips, then this can be seen from the inlet pressure. Is there a log where you can see the problem?
from dodge neon 2.4 srt is. necessary?
under certain conditions, I get a lean mixture. I can?t understand what he?s missing. The PCM is trying to enrich the mixture. Ignition misfires appear on the 8th and 7th cylinders. I associate...
the setting is based on the output shaft sensor and not on the wheels. therefore, the main pairs of gearboxes do not participate here as in NAG1
this automatic transmission can only be indirectly configured
The 2008 Wrangler JK was equipped with 5.7 Hemi driven NGC4 and NAG1 driven EGS52 and a shift selector from wk2.
The problem is in the support of the autostick function. When the first gear is...
did you manage to flash it remotely via j2534 or cda?
there is a parameter whether this system is provided or not. and then parameter 1 shaft or not. and the fact that it is further disabled is a feature of this control unit and the operating system
bypass cable required. hp tuner sell them
how to distinguish a knock from an explosion and a knock from a mechanical part in an explosion system and a compressor
Hello guys everyone. I work at a chrysler, GM, ford service station. I diagnose electronic engine control systems, automatic transmissions, abs, and other equipment in cars. I am also engaged in...
I'm asking))). Why then is the maximum engine torque not shown? 680 newtons.
It is not possible to raise the torque above 600 Newtons. I attach two logs. PCM GPEC2A
108698
108699
108700
Nevertheless, I do not recommend lowering temperatures. The most extreme is low 95, medium 97, high 99.
Why is nothing done in the program to work without catalysts?
106392
leveled the speed of the automatic transmission after 80%. from your data. Also for the test