Hello
Read my car and see IAT2 map is strange , here is stock attached. Could some one give me idea. Or IAT2 map useless !
-could you check stock or tune map and give me advice ?
-could advice...
Type: Posts; User: Targus
Hello
Read my car and see IAT2 map is strange , here is stock attached. Could some one give me idea. Or IAT2 map useless !
-could you check stock or tune map and give me advice ?
-could advice...
could you send your tune ? where are you located ?
Hello,
I am not successful about acceleration after 3500rpm could you advice me what to do ?
here is my tune and stock and tuned file about cruze1.4t at, could you check and inform bad and good...
I did hundreds of S76GM tunes, you can contact with me.
i did it before ,
but
I did it again after you ask me , it is working after resync today .
thx a lot ..
I tried new another two cable with my regular nb that I used with MPVI before, also I tried newly fresh nb and three kind cable its same .
Can not connect to the car neighter VCMsuite nor...
I had my MPVI2 replacing with MPVI interface , two weeks before!
the same E83 that I connect before with MPVI, I can not connect with MPVI2 now.
It gives "dedect protocol failed". i already...
I need to do diagnostics before I tune ,
instead of replacing the interface can I use MPVI2 as a J2534 interface for GDS2 or etc ?
I had similar issue but I dont remember how to fix that .
Could I do Tunerlock for both pcm ?
Does it lock both read and write or only for write ?
How can I do it? Can you show me sample ?
thx
Dont care the list much,
your car E83 ecu could be identified with Hptuners , dont worry about it.
Is it possible to change VIN for 6T40 tcm on Cruze ?
because of defectife tcm board replacement with different ID board for same tcm .
If ID is different can not do sps to change vin.
VIN change is not eneugh to swap controller, you need to write immo and pin code also ..
I just found web site is changed to new , can not get in to my account !
I tried to login , can not ! then I tried register with my email , ıt make new account with my email adress , why ?
I tested fan controller parameters today and check the result by GDS2 , it is disappointed.
E83 module have a mistake I think I couldnt add the picture files to show the states.
which pcm stock.bin files do you need for ?
which ecm ecuipped on it? E78 or E83?
it is related with OS on ecm .
You must check engine diagnostic with GDS2 if ecm can control electric thermostat.
I know even equipped electical controlled...
thx for reply ,
there are one simulate heater circuits that I found , here is the link.
http://www.ac.com.pl/ru-produkty-autogaz/o-/stag-afr/337/
I think should get this and try and see the result.
I am planning to get PLX wireless AFR gauge and shows on android phone.
I could install wideband sensor instead of upstream-sensor1 , and 0-1V output could connect to E83-E78 but needs to connect...
I need to use lock my tune for some testers , to avoid they bring the car to another tuner for copy my tune.
I have some question about tune lock option,
* if the tune is locked, is that lock the ecu reading and even GM service update by sps ?
* is that possible to read by any other tool can read...
I tuned the car (with manual transmission )but result is not satisifed .
Neither pedal response nor acceleration at low rpm(1000-2500) didnt changed a lot.
Here is the stock and tune files , what...
thx ,
Why ECT modifier table does not effect timing advance increase ? according to theese modify timing advance should be seen more 2-3 d3gree because of reduction is less than before ?
thx for the Reply Mark,
ok to back IAT calibration , another theese are ok or good enugh ? Do I need mod any more maps ?
No retard , didnt take alog but I follow the timing advance for high...
Hello Pro's ,
I am coming from Siemens ecu's on GM cars , and have experience and good results about them.
And I had a HPT GM pack but not use and work a lot since 2015.
Here is my works about...