Search:

Type: Posts; User: Wayne Presley

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. I can make them, I've done three so far for the...

    I can make them, I've done three so far for the E39.
  2. you want to do a E39 if it is a swap, e39A won't...

    you want to do a E39 if it is a swap, e39A won't run the alternator stand alone.
  3. Replies
    20
    Views
    5,608

    log the MAP, if the value is atmospheric...

    log the MAP, if the value is atmospheric pressure, then opening the throttle more would make no difference. Here is an LFX miata log showing 98 kPa MAP at 72% throttle 3500 rpm and 96 kPa at 99.6%...
  4. I've done 3 myself. I could do it for you

    I've done 3 myself. I could do it for you
  5. Magnusen fuel rail without a pressure fitting...

    Magnusen fuel rail without a pressure fitting...
  6. The cal is strange, if I command closed loop...

    The cal is strange, if I command closed loop idling using the vehicle controls the STFT pull about 10% fuel. It has an AEM wideband on the A pillar showing 13.0 in OL and 14.3 in CL. I'm going to...
  7. Strange C6 2006 with a magnusen SC. Randomly dies then no start.

    2006 C6 6 Corvette, Magnuson SC kit and it randomly dies while idling. Im getting RPM and cam counts both running and idling. For some reasson the previous tuner has closed loop turned off. I...
  8. Replies
    2
    Views
    447

    3005 GTO Starting issue

    2005 Pontiac GTO and the rest of the tune works very well Idles great, and makes great power. it just starts poorly. If you crack the throttle it fires right up. I've got the VE table dialed in, base...
  9. Here's the last tune, AFR at WOT was 12.3, starts...

    Here's the last tune, AFR at WOT was 12.3, starts and idles great, no knock and pulls great to 6000

    137571
  10. PurpleRam, the 87 octane tune you attached has...

    PurpleRam,
    the 87 octane tune you attached has the VVT disabled
  11. Here is the tune from yesterday and the log from...

    Here is the tune from yesterday and the log from it. I got rid of the COT fueling issue and currently have no knock. I have the SD table fairly happy with WOT set to 12.4 with the wideband and the...
  12. Replies
    4
    Views
    1,521

    Does anyone have a prolink cable that they could...

    Does anyone have a prolink cable that they could Ohm out the red and blue wires to see which pin they touch?
  13. I am 360 feet above sea level in Lower Alabama ....

    I am 360 feet above sea level in Lower Alabama . He watched the CompCams limiter video and he says that is what he put in. I think it should run the 93 octane also.
    Ray, SprayCam and Purple, do...
  14. Also would you happen to know which pins are AD...

    Also would you happen to know which pins are AD 1, AD 2 and ground on the MPVI3

    137313

    1 top left
    2 top right
    3 bottom left
    4 bottom right
    5 outer ring
  15. The logs are from you tune...

    The logs are from you tune (VVTtest4-SprayCam-edit-for-VVT-Enabled-&-Alternate-suggested-Inputs-for-Entire-Tune-Rev1.hpt ) with some mods to the VE table. I have pulled some timing out and the truck...
  16. It doesn't have wideband sensors and I wish I...

    It doesn't have wideband sensors and I wish I knew why it was pulling so much timing.



    Thank you
  17. I read about the volts earlier today and logged...

    I read about the volts earlier today and logged the pedal voltage and the throttle voltage. I added .300 volts to the knock sensors today and logged the sensor voltages directly. How much should I...
  18. Replies
    4
    Views
    1,521

    MPPVI3 Prolink cable pin out

    Can someone check their Prolink cable and the pinout is where it plugs into the MPVI3? Really just need AD 1, AD 2 and ground

    137265
    1 top left
    2 top right
    3 bottom left
    4 bottom right
    5...
  19. Ok I have used SprayCam's VVT SD tune with some...

    Ok I have used SprayCam's VVT SD tune with some mods. I haven't played with the dodge 5.7 much but it doesn't seem correct that I'm getting 4 degrees of knock retard with 14.6 degrees of timing at...
  20. I'll look for each when I connect back to the...

    I'll look for each when I connect back to the truck, Thank you


    I talked with the owner last night and the phaser is definitely installed. I'll check and see if I have an OCV CEL when I get back...
  21. Found it, it was on RinkRats cam idle tuning...

    Found it, it was on RinkRats cam idle tuning thread

    https://forum.hptuners.com/showthread.php?36318-Idle-Tuning-How-To-amp-Guide-(w-pictures)
  22. I just noticed that I wasn't logging aircharge. I...

    I just noticed that I wasn't logging aircharge. I was just looking at the spark table and saw one axis is aircharge. Then looking at the VE tables one axis is in ratio. Is ratio the absolute pressure...
  23. The truck runs much better with the cam installed...

    The truck runs much better with the cam installed correctly. I enabled the VVT and took it out for a drive but the cam doesn't seem to move. Could someone take a look at the tune and see if I'm...
  24. Cam tuning guide, read it two days ago now I can't find it

    It's the multi posting step by step guide that worked so well getting this weird engine combo to run great and want to bookmark it for future reference.
    I would appreciate a link please. Thanks in...
  25. Cam was out of time, customer is dropping it off...

    Cam was out of time, customer is dropping it off this week
Results 1 to 25 of 63
Page 1 of 3 1 2 3