Search:

Type: Posts; User: Deadhooker

Search: Search took 0.00 seconds.

  1. Replies
    105
    Views
    119,292

    Wow. So in order to have an interface with the...

    Wow. So in order to have an interface with the functionality that we expected from the MPVI2 when it was released (bluetooth, stand-alone…etc) we now have to spend basically $600, whereas if we’d...
  2. Replies
    105
    Views
    119,292

    I currently have the MPVI2 and would like to...

    I currently have the MPVI2 and would like to upgrade to the 2+. I was under the impression the upgrade fee was $189 (could've swore I read that on the site), but when I initiate the process, it...
  3. Pro Link analog inputs not recording in Chart vs Time

    I have installed Pro Link/Pro Features for the MPVI2. I am using the 2 analog inputs to log 2 pressure sensors. I am able to see these 2 inputs in the Channels window, and they display data...
  4. Any update on how this worked? I am also trying...

    Any update on how this worked? I am also trying to log 8 egts through the pro link CAN input.
  5. Replies
    8
    Views
    3,349

    It's not just that I'm not receiving anything,...

    It's not just that I'm not receiving anything, I'm not seeing any way to add the CAN inputs (add the channel). The following pic is with the high/low wires hooked up appropriately to the pro link,...
  6. Replies
    8
    Views
    3,349

    8 EGT probes and 2 pressure sensors - all...

    8 EGT probes and 2 pressure sensors - all currently on an Altronics CAN BUS system. I want to input these sensors into the VCM scanner because the Altronics software leaves a lot to be desired, and...
  7. Replies
    8
    Views
    3,349

    According to the instructions, the CAN high/low...

    According to the instructions, the CAN high/low signals actually go to the yellow and orange wires. See the pic. The question is how to set up the CAN input inside Scanner.

    97239
  8. Replies
    8
    Views
    3,349

    Pro Features CAN BUS

    I recently purchased Pro Link/Features for the MPVI2 with the intent of using the CAN BUS input. I can?t find any information on setting it up, nor do I see anything in the Scanner that indicates...
Results 1 to 8 of 8