All I can find is neutral and reverse
Type: Posts; User: stan65
All I can find is neutral and reverse
Any suggestions on a PID to log? I have not been able to find anything to show what gear thinks it?s in.
Thanks
All,
I am very new to all of this. With that being said, in many tables there are different rows based on what gear you are in. With a manual transmission, how does it know?
Is it calculating...
So now I am on a quest for a device I can add to the CAN Bus that will initiate communications.
Anyone?
Received the Dakota Digital BIM-01-2 module today. I plugged it in, and it did not power up.
Figured out power, it is on the plug that passes data to the gauges.
It has 4 wires that go to the...
Thanks for all the replies....
I will try a few things once the roads dry up. hopefully this weekend.
On my list,
Try 120-ohm terminating resistor at cruise end of network. (Will probably...
I will try adding the termination resister at the cruise. It is the farthest from the ECM and is exactly like the drawing. It is pouring down rain here, so I won't be able to try it till the weather...
119894
Here is what I have. There are no terminating resistors at the OBD2 or Cruise.
I have 120-ohm resistors that I can install.
I do not have prints. Gm doesn?t supply schematics with their controller package. They do include the pinout of the ECM.
I believe the Fuel pump control module is on the blue connector, pins 36...
Can anyone confirm the factory Fuel Pump Control Module is on the Can?
Also exactly where do I add the resistor? 6? from the Cruise Module or 6? from the OBD2 port?
Assuming it needs a 120ohm...
Any suggestions on how I can log the Can?
It has 120 ohms.
I think the fuel pump control module is on the bus also. But I?m not 100% l
I was able to get a cheap Bluetooth dongle to make it work also. Had to pair my phone with it...
Not exactly sure what you mean by that?. The cruise control only works when the MPVI2 is plugged in.
All,
I have a 71 Firebird with a 2017 GMPP LT4 Crate Engine with manual transmission (TKX) and I am using the GMPP Controller package. Ihave an oddity with trying to get a Dakota Digital...
Any updates to this? I have a GMPP LT4 with a a TKO and my throttle hangs. I did the torque demands for decel and it didn?t make a difference. Also my CFCO table isn?t available in HP-tubers for my...