Search:

Type: Posts; User: caged

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,271

    It will still flag the code internally but not...

    It will still flag the code internally but not put on the mill light.
  2. Replies
    5
    Views
    1,780

    No not with techstream either.

    No not with techstream either.
  3. Replies
    5
    Views
    1,780

    Its not possible to change with HPT and an engine...

    Its not possible to change with HPT and an engine file.
  4. Replies
    1
    Views
    1,158

    1hd isnt supported as far as im aware.

    1hd isnt supported as far as im aware.
  5. Replies
    20
    Views
    13,691

    70 series or 200? send me your email and ill see...

    70 series or 200? send me your email and ill see what i can do.
  6. Replies
    20
    Views
    13,691

    Its a virtual read. Write is about 3-5mins.

    Its a virtual read. Write is about 3-5mins.
  7. Replies
    19
    Views
    15,747

    Timing calculator

    Im looking for the link to the timing calculator that suits HP. It looks like all the old links have been taken down?? cheers
  8. Thread: E38 vat's

    by caged
    Replies
    5
    Views
    2,011

    It was the Vats write option. I did another write...

    It was the Vats write option. I did another write entire and it was all good.
  9. Thread: E38 vat's

    by caged
    Replies
    5
    Views
    2,011

    Theyre all turned off. Here is an older version.

    Theyre all turned off. Here is an older version.
  10. Thread: E38 vat's

    by caged
    Replies
    5
    Views
    2,011

    E38 vat's

    Hey iv got an ls3 E38 with 12639270 OS. Its been wired in stand alone, i disabled both vats and starter patch and flashed it in via write vats. The car has crank and cam sensor output and fuel pump...
  11. Thread: 18+ Ghost cam

    by caged
    Replies
    7
    Views
    3,342

    The roush is custom Os which makes it different...

    The roush is custom Os which makes it different than normal, also being a 2018 roush I'm guessing it's speed density and no afm like the 2018 roush mustang?
  12. Replies
    19
    Views
    7,440

    The injector flow rate high and low, then...

    The injector flow rate high and low, then multiply the whole maf table by .9 and just scale as normal. It's just a crude way of dropping your airflow down to check if you're hitting some kind of...
  13. Replies
    27
    Views
    11,246

    I just play with the throttle % untill it's...

    I just play with the throttle % untill it's almost pedalling its self.
  14. Replies
    19
    Views
    7,440

    you can try reducing the slopes by 10 or 15% and...

    you can try reducing the slopes by 10 or 15% and pulling maf out as a test.
  15. Replies
    7
    Views
    2,459

    Your maf is off abit but not terrible, adjust...

    Your maf is off abit but not terrible, adjust your pe wot lambda till you see what you want out the back with the dyno wideband.
  16. Replies
    0
    Views
    756

    2 step neutral rev limit

    Hey any problems using the neutral rev limit/2 step on a procharged 2016 mt82 coyote? I was a little bit iffy because I'm assuming it's fuel cut and I make about 8psi of boost there. Cheers
  17. Replies
    25
    Views
    8,127

    Why are you wanting to swap? Imo the roush os...

    Why are you wanting to swap? Imo the roush os isn't that special.
  18. Replies
    35
    Views
    12,695

    Use returnless data if retunless. You can't just...

    Use returnless data if retunless. You can't just swap between data.
  19. Replies
    11
    Views
    4,658

    You also need the latest beta and firmware to...

    You also need the latest beta and firmware to open that file. 2.0.107 is the current fw and 4.1.372.0 is latest beta.
    Not sure this file will help you as roush has its own custom os and run map...
  20. You have a fuel pressure problem abit higher up...

    You have a fuel pressure problem abit higher up too.
  21. Replies
    9
    Views
    3,808

    Here is the std 2018 GT file as a compare and the...

    Here is the std 2018 GT file as a compare and the Roush 2018 supercharged file.
    Iv tuned heaps of 2016/2017 blown Roush cars on the Roush Os previously, I could get ok power out of this 2018 but 80%...
  22. Replies
    9
    Views
    3,808

    Sorry for the delay, I kept getting a definition...

    Sorry for the delay, I kept getting a definition miss match when I went to open any files with a Roush Os even though I already licenced and tuned this car on this laptop with the same beta. That...
  23. Replies
    9
    Views
    3,808

    Yeah will tomorrow when im infront of a laptop.

    Yeah will tomorrow when im infront of a laptop.
  24. Replies
    9
    Views
    3,808

    2018 supercharged Roush Mustang.

    Has anyone been playing with a new 2018 mustang with the Roush OS and tune? Full speed density with a map sensor and no maf now. One thing I noticed is the cam timing is fixed on the exhaust at...
  25. Replies
    0
    Views
    710

    Permant dtc's and no start on E38

    I know exactly how the permanent dtc's work and how you need to do a universal drive cycle, but what happens if for example a car comes in with no rear o2s and the fuel control moduals been replace...
Results 1 to 25 of 32
Page 1 of 2 1 2