It was not required to be edit much unless the characteristic of the engine output was changed alot.
For a ecoboost with bolt-on only required to edit the mid to high-end part. By edit means...
Type: Posts; User: speedjet
It was not required to be edit much unless the characteristic of the engine output was changed alot.
For a ecoboost with bolt-on only required to edit the mid to high-end part. By edit means...
1st, is the clearance issue.
2nd, you must make sure u had fills up sufficient transmission fluid. After certain bare-in time, You need to check the fluid.
1st, you need to add all type of sources channels into your log. So others can help u. We can't get any idea from your current log.
Try adding throttle sources, torque source, fuel source, VCT...
From my easy understanding, the speed density calculator is used to calculate the VE of the engine in order to form the quad, offset, slope tables.
For the starting point will be adjust the correct...
From my experience, the speed density are not required to be change.
Unless u had make a big changes to the engine. Such as turbo changed to NA or changed super hot camshaft.
Hello everyone,
I recently faced a problem with my ecoboost mustang. I had maxed out all my CSL and LSPI limit.
Yet I'm facing the CSL limit and cause my throttle to shut off then pedal dead for...
I was facing this limit too.
The limit will cause my pedal to go dead for few seconds.
I would like to completely disable this limit. The car was for track only.
Log attached
92869
I would recommend you take some time to sort out your datalog channels 1st. You need to add some important channels and delete others.
You would need to add torque, throttle, airlimit & fuel...
There is a knock during your 3000rpm to 5000rpm. You will need to enrich your AFR in order to get a good combustion to not cause your CAT to overheat due to mixture too lean.
Especially you had...
Hello,
I have a S550 Mustang GT with 6r80 that I'm considering to swap my transmission out to a Sequential transmission or a close ratio MT gearbox for track only.
All the engine tune was good...
Anyone knows what do this means on 1st & 2nd gear means? 89050
What if I lock the TCC at 2nd gear do I need to edit all the unlock and slip value to 0 ?
87624
Same Tipout Limit happen.
Do I need to adjust the Spark Only Ratio Table?
Also the mapped points was enable by me from 0-12 and OP. Do you mean that I should disable some mapped points to 6 left?
Tune attached.
The actual top speed with this log is 109mph. My speed limit under speedo was set at 300km/h.
Is there any speed related limit?
Hi all,
I had a 15GT with whipple SC. The kit run goods with my custom tune but had some problem during the shift after 3rd and into 4th.
Then there will be a Tipout Limit happens and completely...
is all the flare tools limiter disabled with this file?
I had a pcm returned to stock and also read the whipple tune. If I flash the whipple tune using hpt into this stock ecu will I still get the flare tools limits? I do not have a flare tools now and...