Update: It runs, can't say for certain what exactly it was. Only thing i can figure is i had a connector that wasn't tight. After pinning out just about everything i could think that would cause this...
Type: Posts; User: aj89
Update: It runs, can't say for certain what exactly it was. Only thing i can figure is i had a connector that wasn't tight. After pinning out just about everything i could think that would cause this...
I understand the issues using the 2017 PCM with the 2016 harness as there are some major differences. The diagrams I can find online everything looks the same 2017-2018. Continuing on checking the...
For what it's worth here is the log file for two start up attempts. Both fire for a second then stall out. 114868
I am heading back to work tomorrow for two weeks and will be unable to test or pull...
I just found a few more diagrams that state the PCM Black connector Pin 18 IS the correct pin for the Rail Pressure Sensor 5V reference. Which makes sense because I don`t have any codes to do with...
I purchased my Harness from Swap Specialties. I have the 3 wire Rail Pressure Sensor, indicating a 2017+ model as Shrek listed above. I checked my wiring from PCM to Rail Pressure Sensor against the...
I triple checked the fuel pressure, all is well. The wiring is good. I verified both of these by borrowing a 2014 PCM from a buddies project and it fired up first time and idled. It has to be...
Here is what i have so far:
- under the OS tab I have the "VATS Patch 1" set to DISABLED
- under System - General - Starter Relay - Starter Diag is set to DISABLED
- under transmission - manual...
I am new tuner, I am building a 67' C10 and purchased a 2017 L86/8L90 combo, after installing the powertrain and hooking up to HP tuners I have found that the PCM I recieved with this assembly is...
Does anyone have a factory tune for a 2012 Ram 3500 6.7 cummins, manual transmission? Nothing in the repository.
Thank you