Search:

Tried all of the above until the program crashed. It takes about 10 seconds for it to request the key cycle so I believe it has already timed out by that point. Behind the request screen you see it...

Didn't take note unfortunately. Was first time I had been instructed to disable PO605

As title, unable to write a file to BA Turbo. Seems to have been an issue since updating software. Was able to flash once with write entire but no luck since.
Seems to take a long time once Write is...

Did write entire successfully.

Read a BA with the latest non beta version, made some changes and went to write the file. Came up with the the box saying to disable PO605, so I did. Tried to write and came up with the x7 negative...

Having exactly the same issue. Did this ever get resolved?

Sorry only got the one short clip of the engine bay at speed.
Initial out of the hole power is very good, just cavitates so cant apply full power anyway so impeller change needed to load it more....

Yeah I don't know what was going on but that was the only way I could get it to work. What probably didn't help was that I thought I was on the latest version as had updated it but an earlier version...

Only reason to bother is that It becomes a more cost effective conversion without the added expense of the ECU.
That is the only reason.

Update.
Had some issues and could only get it to load with Beta in the end.
There is still some sort of torque management going on but it will allow full throttle until approx 3400 rpm at which...

Link G4+

Didn't think this forum was the place to discuss an aftermarket ecu... Maybe on the other forum.

Link to short vid. Sorry about the filming, choppy lake and 90 odd kmh made it a bit hard.
...

It wont attach the vid.
Plug in full control of cams, e throttle etc.

Having an issue trying to load the new file...
Have emailed support.

On another note it is going awesome.

Fixed it for you!, at least in my experience.

Well busy day. Used a aftermarket ecu to get it up and running and validated today.
Will revisit the factory ecu once i have finished doing what i need to do with proving the combination.
Will...

Thanks.
Will let you know how i get on tomorrow.

Thanks Grant. Had a quick look and under trans i only have general and three parameters still? No option to disable or enable trans?

Thanks for the offer jet, will let you know.

Thanks for the clarification.
There have been a couple of offers so will ask thanks.

Thanks but as i had explained in a previous reply, I think to Grant, it would not let me read with 2.24????

Thanks Darryl.
Yes the VSS comes as a can message and nothing else connected to the can lines so explains that thanks.
Will do thanks.

Cool, I had asked about this previously.
1 Do i need to flash it back to the original tune, then read with 2.24 from there?
2 Do i need the trans connected ( owner has sold it ) as I believe that...

I hear you. Care to comment on y previous reply to you?

Ok. Cant remember where i had got to, was trying all sorts but this was the last attempt.