Everything was perfect. Thank you
Type: Posts; User: [email protected]
Everything was perfect. Thank you
thank you
No I had it set to manual because I had a turbo 400 transmission. Do I have to set it to 4l60?
Alvin,
I programmed transmission. I was wondering why transmission was left manual not 4l60?
Thank you
thank you
yes 1st gear only
Attached file
Thank you it's for a demolition derby car. It mainly stays below 40 feet of movement. So figured programming was easier solution.
I have a 4l60 and 5.3 in an off road vehicle. Want to program so transmission is low and reverse only. Can someone please help me?
Nevermind I found a post showing me how.
Can you set up VCM Scanner to be able to record with Bluetooth?
I turned DTC on that I needed.
does this tune look good?
thanks
I did not change map settings that's what was in module.i will change it
Thank you
I am putting a 5.3 in a demolition derby car. I programmed module. can anyone look at tune to see if it will not go into limp mode if it gets hot? if fuel table is rich enough?
thank you
Thanks guys. I will be using a pressure regulator and adjust to 58psi.
I have a set of 12613412 injectors
Injector # 12554271. I will go through and turn check engine light back on. Engine is going in a 1972 Chevelle
I built a lq9 with 243 heads, texas speed torque 2 cam, ls1 intake with 12212156 injectors and 95 mm throttle body. I started it on my test run stand. it would not idle. only way i could keep engine...
Could someone take a look at my tune and tell me if I'm doing this correct?
Thank you
I'm slowly learning about tuning. lol. I disabled cylinder charge temperature complex model. changed high rpm disable to 1 rpm in dynamic air flow, disabled stft and ltft. because no o2 sensors...
think I did everything correctly
thank you
I'm new to hp tuners. i bought a 0411 computer was already supposed to have a demolition derby tune. could some one look at it and let me know if it a good tune? I'm learning but derby is coming up...