We should work out a deal so HPT can hang some banners in the shop ;)
Type: Posts; User: Casey
We should work out a deal so HPT can hang some banners in the shop ;)
No.
Relax 10_SS. Stand alone datalogging has always worked. The manufacturer of the memory chip changed the ID and the firmware does not recognize it and failed it. Firmware updates are taken very...
Write calibration only. Write entire erases boot section which could kill your VCM. Make sure your battery is @12v, and try low speed mode (uncheck high speed mode box).
3-4 clutch is a known weak link and probably the cause..
They are not built backwards. We don't want to repair interfaces for bent pins. Why dont you unplug the OBDII end from the vehicle first before connecting the MPVI, then you solve all of your...
Rob and Doug are friends of mine and it has nothing to do with picking a shop. Its an internal version of VCM Suite that only I have. We have to test this stuff somewhere because if something goes...
We internally tuning a 2005 Magnum with a mild head/cam package right now over here:
D.T.S. - Strictly Performance
7444 Reseda Blvd. Suite K.
Reseda, CA 91335
818-262-7409 Cell...
The cable is made to HPT specs and not available anywhere else. Is there a reason the cable cannot be coiled up and tucked away under the dash? I know they are tight under there, but I didnt think...
Does it do this with any F150 or just yours?
Our interface works with GM/Ford/Dodge (and a few others).
We wont be able to fix this without actually looking at a vehicle. but as the Mfgrs use the...
Beta and stable are not relative. Beta can be as simple as a new OS update.
Please add the show again box as this is really annoying for those who use it.
-Ken
Any good musician can hear the note and nail the tune without one of those :D
-Ken
Yes its pin 16. Just cut the wire on that goes to the OBDII connector and route it to some fused ignition source.
Sounds like you are shorting out the power pin on the OBDII cable to something...
The inputs float and are not referenced to ground or 5V. The stuff you are seeing is the internal bias on the buffer IC and does not cause offsets.
-Ken
Run the power wire of the OBDII port to a switched igntion source instead of battery...
There should be no sparks when you connect the USB cable. If there is, something is wrong with your...
Sorry, we do not.
Is there a reason you cannot save the original file from the VCM when you read it out? That would be your best option.
-Ken
Jay is off sick today.
Is there something one of us can help you with?
-Ken
Yeah. The jumper controls the injector timing per distributor reference pulse.
-Ken
The info in this link http://www.hptuners.com/forum/showthread.php?t=9228 was created for the heavy duty trucks using 7.4/4L80E. No clue on the 5.7/4L60E you have, but I think the first year for that...
Nice job on the welds bro ;)
Where did we mention we would in this release?
Who made the headers on that Vette?
They look nice (actually the whole setup does).
Ken
The 98's do not have the checks and balances the 99 and later OS's do.
So whatever you do, do not try and write calibrations from other vehicles or mix up custom operating system files. You will...
"Rear Fog/ADLD/TOP SW" ????
Seems to ring a bell for me on some other GM vehicles.
-Ken
Duh.
Notice who left the body off his truck so it wouldn't get trashed?
Keith had to talk to me 3 times about no burnouts in his planters :burnout:
I did get even with him though. His GF...