bump
Type: Posts; User: jason72
bump
here is a log where it almost stalled pulling in to my driveway. (at the very end)
I attached a log. of course it didn't act too bad but later in the log when I rev it up a bit when it comes back to idle it does dip... Thank you for the help.
ls1 h/c/ex 6 speed. 2002 vette. I have been fighting this for about a year now. If I start the car cold and let it warm up it will run fine until I shut it off and start it up 10 minutes later it...
update. Here is my updated tune and log.
never mind. I figured it out
I am done tuning my VE table and fuel trims are all to my satisfaction while in SD mode. Now I have to tune my MAF table. I am confused as to how to do it. There seems to be a lot of opinions. Is the...
I was going to do the ve and maf at my leisure. I know they could be better. I also noticed the injector % also. it runs and drives great. no issues at all thanks for the advise.
I think in the scanner you have something other than ltft b1 sae selected. I think you are logging average which is not in your channel list
I was able to take a log on my ride home today. I did find a find some spark knock and modified the tune to get rid of it. the othe thing I had was after smoothing the timing table my timing was a...
I am pleased. The only thing I am going to double check is for any spark knock, I saw on one of my short term fuel trim logs I had a 2* retard at one point. I will fix that if needed and send a log...
I will get one and post it tomorrow. Is there anything in particular you would like to see?
Does anyone want to look over my tune?
Details: 2002 C5. Manual trans, borla cat back, ls1 stock cubes, texas speed 5.3 2.5 heads, ls2 intake, cam-231/234 @.050 .629/.615, lobe sep 111, 109 icl....
Thank you
Can someone tell me if this histogram is set up properly for stft tuning? Thanks
That's what I was going to try. Just took my base tune and applied that. You can see in this tune I will load up to the car tomorrow. Then I assume I can lower my base air flow? Thanks for looking!
Is it possibly like this because I have to (did not) cut idle fuel on ve table?
Here is my idle histogram
Hi guys. This is my first post but I have been reading for about 3 months. I am currently tuning a LS1 with a cam install.
The question is, I used the idle config sequence that is talked about a...