Search:

Bump.............Again...........

Bump for help guys.........

I have been able to load a few MAF tunes now but I need to get the 2bar operating system working to finish the car up.

Why would it only freak out when trying to...

I am trying to apply a 2bar operating system on a 2004 LS1 C5 Corvette and I am having a little problem.

I have the 2bar tune all worked out and I am ready to do the entire write. I hit the...

Well it is fixed. I had the car reflashed at the dealer then I converted the new flash to the 2 bar operating system and it seems to be working.......

Thanks again guys for the help.

Correct me if i'm wrong but excessive smoke coming from a diesel is not the best way to make horsepower, right?

I am wondering about specifics though. What is the argument either way? I'm not...

Yes, I did an entire write when I converted over to the 2bar operating system.

First I saved the tune under a new name specifying that it was a 2bar tune. I then loaded a VE table from another...

This is just a really safe base tune. I always make the PE & BE the same at first so that I am not haveing to chase the commanded AFR ahile I am dialing in the VE table. Once I know VE is dialed I...

2Bar sensor is installed and the car seems to run fine.....

Yes.......

I am working on a 2006 Z06 and I am having trouble getting the car to go into SD mode. I updated to the 2Bar operating system, modified the tune by filling in the VE table and turning off the MAFand...

I am running an AEM Wideband with the o2 sensor post turbo. I have the AEM gauge selected as an auxilery input on the primary table. The problem is that the scanner is constantly showing .5 to 1...

So here's what I'm running into...

I dialed in the MAF curve with the stock injectors in preperation for the new deatsch werks 65# injectors.

These injectors flow 66.7 lbs/hr @ 43.5 psi which...

I have a factory trans cooler. Is that enough? At what temp is the trans too hot?

Bump for help...

I am trying to keep my new transmission together so I am wondering if there are any do's and dont's when tuning a transmission with a shift kit? What kind of line pressure should I be shooting for? ...

What is the PCM using to calculate G/CYL for the timing table on a 2 bar operating system?

I am going to be installing a Pro-Flo intake and I was wondering if anyone here has any experience with this manifold & boost? I am running a 2 bar operating system and am not expecting any major...

Cool thanks for the info...

65 views and no reply's?

No ideas at all?

^^^^^^^^^

I am thinking it might have something to do with the predicted air mass / air flow coefficents but I'm not sure what changes I should make.

No ideas?

The car is a 2009 C6 vette with twin turbos and a 2 bar operating system.

In the log you will see that the timing fluctuates wildly during spool up then levels back off. I'm not sure that it is...

So I blew up my 4.8 awhile back and swapped in a built for boost 6.0. It runs great and I really have no problems but I was wondering about something. I noticed that under engine > general > type...