Search:

This is going to go swell, isn't it?

Rather easy to turn an auto trans PCM into a manual with Gen 3s, just disable all the trans-related DTCs and disable Abuse Mode. It's on Gen 4's where you can't convert them just by making edits,...

https://www.hptuners.com/my-account/tunerepository/ - don't take this as an endorsement of the 'use an 8.1 big block tune file' thing, that's just not a good idea.

98 kPa key on, idling at ~40 kPa? What do you see that makes you suspect it's bad? Not slyly trying to say it's not, I just didn't see anything in the log that stood out.

1963 Buick Special - https://www.ebay.com/itm/386950846379

$3500, running/driving condition and not something that's been marinating in mousepiss for the last 4 decades, all aluminum 215 V8? It's...

You have HP Tuners, right?

Do this. Post the tune file from the original (broken) ECM, and a short log file. The log can be as little as 10 seconds of nothing but key on engine off, I just need...

145609

Whatever is happening is not caused by the act of reprogramming a used ECM with SPS.

Did the VIN you're programming it with come out of the old ECM, or off the VIN tag or door sticker?

Let it gather info (the old VIN) from the old ECM, instead of inputting it yourself. It should walk you through the steps, tell you when it's OK to turn things off and swap ECMs, etc. Or at least it...

Oh, well we're well over 50 years then, I think I was at 22 when I finally gave up.

We're not trying to be funny, we're just two guys that have combined between us something like, what is it, 45, 48 years in GM dealerships?

145606

145607

The last bad ECM I saw in a GM looked like this...

145602

HP Tuners only reads/writes 6 of the 8 segments, GM SPS writes all of them.

What are the full VINs of the calibrations you're trying to flash into it/them?

But hang on, how can it be a TMAP if there is only a single sensor output pin? These do not do any kind of weird multiplexing, they output analog voltage.

Odd that you wouldn't mention this...

Just get a proper LSA 3-pin non-T sensor.

https://forum.hptuners.com/showthread.php?96757-Injector-Data-Repository

If the replacement TCM is new-new and has never had any kind of flash before, HPT won't detect it. If it's a reman and still has some old file in it, or has a generic placeholder calibration, then...

This is what they look like with injectors or O2s bank-swapped

145573

0hz if the MAF is removed, 1hz if it is just failed temporarily for tuning VE. P0101/P0102/P0103 set to MIL on First Error. Engine > Airflow > Dynamic: Dynamic Airflow: High RPM Disable = something...

If you only need to program one or a few ECMs it's easier/cheaper to just buy them used and pre-programmed to a VIN you supply.

First, find a file in the repository with the stuff you need. Take...

My oil pressure gauge has a needle that will sweep the full range and everything like a real gauge but in use it only has two positions, zero or 40psi.

At least I think I understand the reasoning behind exceeding the max on that one, it changes the shape leading up to/after the peak and the dwell time at 194F, even if the value the ECM uses never...

Every cell that got populated in the trims error chart is lean in that log, MAF Fail is = 100hz, P0101-103 are set to No MIL instead of First Error...

So the file needs to be set up by someone...

Prove you are human: How many forward gears does a 4L60E transmission have?