Search:

Its not that hard... I had a Ramjet and the VCM is the same way. Stick with it, both are great intakes they just take an extra couple minutes to tune. If you look around you can find the tables that...

Did you try LS9 injector data? Maggie used to ship those with the 1900.

Pretty close to what I found today... hit 655whp at 116IDC at 70-72PSI at the rail. Time for more injector!

Did you find the limit? I did 575whp on 9-10lbs at 58PSI and ZR-1 injectors were ok, thats through a 6L80. I'm raising it up to 13lbs and raising fuel pressure to 65lbs now through a TH400. We'll...

I usually get them immediately in my email. Load the new key and your good to go.

Did you check the repository? Theres a 2011 Camaro Whipple file sitting in there.

2011 Chevrolet Camaro
Engine: 6.2 V8 - Manual
Submitted By: Mike Applegate

Download this Tune File
...

True I cant complain too much, mine lasted 62k miles and went 10's but started slipping and acting funny after a while. Its frustrated me since I purchased the car though... so glad its gone!

No...

Yes a TH400 3 speed. I didnt want to spend $3500-5000 on a 6L80 that might not even hold the power and spend countless hours tuning it at the track. To me thats not worth it. There is no guarantee...

Gotcha so the car will run fine on the manual file but TCM will still need to be plugged in, I'm ok with that. Having/removing the TCM is a secondary problem, I have it plugged in and tucked out of...

Other cars have flashed in manual files without messing with the BCM and have done manual swaps which run fine. The first day we put the trans in the car worked fine, no issues under load, ran fine...

No more ideas? I tried all the settings to try to get the wheel sensor to the ECM. I changed everything to GXP manual settings but no change. I'm going to flash in the Holden manual file today and...

I tried jumping the trans pins the first night we put it in. However the car wouldn't start. I think it still needs a neutral safety signal. Which I also tried setting the trans type to manual and...

Went over to the car for lunch. Tried disabling all tq mgmt and tried all the VSS settings. Back to exactly where I was before. Ran it up and down the street a couple times. See below.

Thanks
...

I agree thats why I never purchased one.

Does the TR-6060 pull VSS from the trans or from an ABS sensor? I noticed on the manual file the wheel speed ouput is enabled, but disabled on the auto.

I'll try to get a log later today, the car...

Yes I have the latest beta as of a few weeks ago.

There has to be a way for it to work because people have used these things in rock crawlers and boats with no VSS input.

I tweaked my buddies...

Gotcha... missed that. On a stock cubed big cam G8 the 102TB was good for about 6whp, I would think on bigger cubes it would be worth more. Especially if the rest of the intake is cleaned up. Believe...

For some reason my ECM only takes write entire, it errors when I try write cal. Another person had this issue and had to send in their hpt file for a minor tweak by support.

I have no worries with...

I downloaded a 2008 Holden Commodore Manual file... would it work if I load this?

I have an E38 12624402 ECM.

Is their a way to disable P0658 "Actuator Supply Voltage Circuit Low"? Its not listed amongst the other DTC's to set to No Error Reported. I recently removed my auto trans and its the last code I...

FAST 102 certainly worked on my G8 even with stock cubes, just a big cam and touched up heads. Easy 20hp gain on my car and more above where the stock manifold dropped off. Also gained power on my...

I have a 2008 G8 GT with the L76 and 6L80 that was tuned well but ran into slipping issues with the 6L80 once I added a good bit of power (supercharger). I removed the 6L80 and installed a TH400. I...