I have changed rear ends in car. I have a question about tire height, is it from center or top of tire ?
Type: Posts; User: 86MonteSS
I have changed rear ends in car. I have a question about tire height, is it from center or top of tire ?
I fiqured it out :)
Heres cfg and log if it helps. Thanks in advance.
Also have a question about where to paste avg. RAF meaning what exactly? All the parameters I see are no where near the averaged number.
I have the Russk.cfg file but it shows an unsupported parameter. I went ahead and logged a start up. But not sure whats missing. Here are the ones I show:
Eng RPM
Idle Desired Airflow lb/min...
Would like to thank Bill for helping me out with problem. :cool: I was trying to log more than 24bits with stand alone.
Done thanks
I can read/write and scan with laptop just fine. But i have been trying to get scan with just cable. I did it exactly like the help file said to(so please don't direct me to the help section). I hit...
I agree :)
Ok fiqured out the idle airflow numbers. Now to Russ K idle thing...
Thanks for info. Once I figure out exactly how to do what you said I will try it. Lol remember new to Hp Tuners....
Specs in sig
My problem is when I shift into D or R it either stalls or come really close to it. It idles fine and idles in gear just fine. And have some cruise control effect, not nearly as bad...
Just recently got HPT. Needed a scanner to read IAC's, Closed my hole on butterfly and car ran badly. With alot of reading and searching site I found the info to get it to start and run smoothly....
not sure what I did but it works now :)
I did that, it doesn't seem to reconize cable on Win7 laptop. I found another post on this and tried the drivers as they did but didn't work. Can open file, just not save it.
Can I use editer on 2 different laptops w/ just the one cable ? The one for the car is small. The one I use in house is easier to see/use. I have software on both, I read PCM with small one and saved...