Search:

Type: Posts; User: BackyardTurbo_FTW

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    178

    91542 Here you go. Def don't try loading a 09...

    91542

    Here you go. Def don't try loading a 09 on a 10, it doesnt work!
  2. Replies
    1
    Views
    111

    Short answer, no. On a lot of these newer cars...

    Short answer, no. On a lot of these newer cars they don't actually read the ECU, they just check the OS version and supply you with a compatible stock file to start tuning from.
  3. Well, on E85 that Air Fuel should be good as long...

    Well, on E85 that Air Fuel should be good as long as you aren't running some insane amount of boost. But I would say the timing is a solid 10* off (again, considering a reasonable boost level)
  4. I would also add a little fuel to PE, its set for...

    I would also add a little fuel to PE, its set for 11.8, I would shoot for 11.3 area personally. Also, the timing seems pretty low!
  5. I have no experience with this vehicle, but I...

    I have no experience with this vehicle, but I would set this table to match your 6200 cutoff and see if it helps. Seems like this should fix it!

    91224
  6. Replies
    5
    Views
    293

    Its not uncommon for stock tunes to be set at a...

    Its not uncommon for stock tunes to be set at a higher timing amount and then they rely on the knock sensor to adjust the timing for different qualities of gas, air, etc. BUT, OEM's will also set...
  7. Replies
    5
    Views
    293

    no, thats the amount of timing it is pulling...

    no, thats the amount of timing it is pulling back. Should be easy to compare your actual timing to the timing table and see you aren't getting the commanded timing amount
  8. Replies
    3
    Views
    118

    Just watch because some of the idle cells are -...

    Just watch because some of the idle cells are - values and won't adjust correctly doing copy/paste special from the chart in the logger. It will end up moving the value in the wrong direction!
  9. Replies
    3
    Views
    118

    Make sure you are logging MAF Sensor period 1 and...

    Make sure you are logging MAF Sensor period 1 and 2 in your channels list. Also, check the graph properties and make sure the settings match this screenshot

    90407
  10. Replies
    3
    Views
    407

    My intake goes from 1 to 22* from 3k to redline....

    My intake goes from 1 to 22* from 3k to redline.

    My Exhaust goes from -12 to -2 from 3k to redline.

    Def gained everywhere on my car
  11. Besides just deleting the codes for specific...

    Besides just deleting the codes for specific faults there are also cat tests and downstream o2 tests you can disable in the engine diagnostic tab. Try disabling those and see if that helps!
  12. Replies
    3
    Views
    251

    If you connect to your car and press read it will...

    If you connect to your car and press read it will supply you with a stock file
  13. Replies
    14
    Views
    3,140

    Not that I can see. I even downloaded the latest...

    Not that I can see. I even downloaded the latest Beta, there is nothing trans related in my file available
  14. Replies
    3
    Views
    407

    There are definitely gains to be had adjusting...

    There are definitely gains to be had adjusting cam timing. Especially noticeable in the top end!
  15. Replies
    5
    Views
    397

    Are you turning the key off and on between...

    Are you turning the key off and on between flashes or just doing repeated flashes with the key on the whole time?
  16. Replies
    4
    Views
    409

    I wouldn't just start changing values all crazy. ...

    I wouldn't just start changing values all crazy. You should have a tune for the stock injectors with the MAF dialed in, swap injectors, run the car and see where the LTFT drifts to, subtract that...
  17. Replies
    4
    Views
    409

    1k is pretty large compared to stock! How far...

    1k is pretty large compared to stock! How far off was the LTFT from the stock table when you logged it?
  18. SOLID!!!! Do you have E85 near you?

    SOLID!!!!

    Do you have E85 near you?
  19. Replies
    2
    Views
    662

    There is no transmission tuning. Someone from HP...

    There is no transmission tuning. Someone from HP might have a stock file to browse but you won't be able to open it without owning a MVPI2
  20. BUT, did you raise the idle speed when doing...

    BUT, did you raise the idle speed when doing this? On the Mustangs I know they idle around 1k when doing the "ghost cam" thing
  21. I dont think that beta is public. Im not showing...

    I dont think that beta is public. Im not showing anything different in the publicly available latest beta
  22. Sounds good! Ill prolly give it another shot...

    Sounds good! Ill prolly give it another shot just for "science purposes" lol.
  23. Have you raised your permissible tq from pedal...

    Have you raised your permissible tq from pedal table??
  24. I would assume if you bought a tune from MEP that...

    I would assume if you bought a tune from MEP that he tuned the cam timing tables. But there are definitely substantial gains to be made over stock if you're starting over with the cam timing!

    Ive...
  25. Replies
    18
    Views
    736

    We have different operating system numbers

    We have different operating system numbers
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4