hello,
i need stock file for Jaguar F-type 2015-2019 5.0.
anyone can help?
Type: Posts; User: teamjin
hello,
i need stock file for Jaguar F-type 2015-2019 5.0.
anyone can help?
can anybody share stock file for ford explorer 3.0 PHEV?
thanks a lot ..
can u tell me low slop ?
stock = BR3E-F5A
bigger = AF49-1900
thanks.
but i knew flow rate@ pressure only.
Do i have to change is all? flow rate , pulse width ,Limits ,Rail temp , Offset , Injection timing , reference angle?
change bigger injector
what should i change in HPT editor?
do i have to change in red square line only?
116608
hello everyone.
i have few question...
i have install supercharger on 2017 ford explorer 3.5 ti-vct.
and using AEM Fic8 piggyback for fueling and spark advance, but it has a problem about relearn...
thanks a lot bro.
i have few question... if you knew answer.. please.
i have install supercharger on 2017 ford explorer 3.5 ti-vct.
and using AEM Fic8 piggyback, but it has a problem about relearn...
hello.
i have a question about transient fuel.
Is higher number means increase fuelling?(going to rich afr?)
ford explorer 3.5 N.A installed supercharger kit.
can transient fuel table adjust AFR...
is higher number means increase fueling?(going to rich afr?)
ford explorer 3.5 N.A installed supercharger kit.
can transient fuel table adjust AFR during boosting?
Thanks guys.,
2017 ford explorer 3.5 Ti-vct..
which table in vcm editor sbould i modified adding boost to an NA ford Vehicle?
thanks
hello everyone.
after write vcm(change injector flow rate,) do i have to reset LTFT STFT Fuel trim?
86151
2014 gm chevy cruze 1.6t
86114
86113
top of thermostat has 2 electric wire.
stock thermostat. 105'c
thanks..
so with out thermostat open early,, controls fan turn on low temp is not very help for cooling coolant......
86095
cruze 1.6t A16LET
factory stock injector spec: 3.54 g/s @3.0bar, VCM Read 4.01 g/s.
uprate injector spec : 4.35 g/s @3.0bar ,
what should i write flow rate for uprate injector?
i tried...
thanks.
i checked thermostat. it works by heat coil, heat coil push wax type.
so i guess ecm control heat coil timing..
is there anyway can control thermostat open timing?
so stoichiometric AFR is 14.29, if i wanna 12.0 AFR should calculate 14.29/1.2=1.190(Power Enrich EQ Ratio)
is it correct?