Hi,
I have a 2017 Corvette 7speed, looking to adjust the throttle response. Looking at the tune and could not find it,
is it adjustable?
Thanks.
Type: Posts; User: wrc
Hi,
I have a 2017 Corvette 7speed, looking to adjust the throttle response. Looking at the tune and could not find it,
is it adjustable?
Thanks.
I recently noticed my Jeep SRT8 not running right, it has a hesitation off idle and runs a rough on acceleration, worse when cold. I scanned it and found the long term fuel trims for one bank was...
Is there anyway to change or rewrite the VIN for a module. I am trying to replace a failed component with a used part
which has a different VIN.
I think you have to look at the Idle Torque Throttle PID settings for drive, you should make some minor changes to compensate for the intermittent dipping. Try bringing in the adjustments a little...
Would you please expand on that, I do not understand.
Thank you:)
In looking at the tune on my 2010 Jeep SRT , current stock tune has Min @ 20kpa and Max @ 20kpa. In my Logs kpa never goes below 19kpa for any length of time, should I raise Min setting to say 23kpa...
I would like to know if we have any control over BCM controls. I am looking into adding Hands Free operation to my factory radio with a
factory kit. It requires that the vehicle be taken to the...
....
Just following this thread, question, is the proper way to adjust these settings to decrease all the rpm delay by 10% to start or just the lower rpm speeds?
Thank you for the information and instruction. Very helpful!
So that I might have a better understanding of how this control works. If a vehicle is over the desired speed, you would increase the negative side of the scale to increase the torque to close the...
Quick question with respect to the -1000 to +1000 scale on which side of zero is it adding rpm? Additionally if changes are made to that scale, for example reducing the ends from -+1000 to say...
The option is in Scanner under the Vehicle heading in Diagnostics and Info.
If I am correct I do not think the Diablo tune makes any changes to the trans settings. What I would do, if you want, save the Diablo and stock tunes and use the compare feature. See what if any...
Will you also be changing the PE Ratio table?
I was looking at my stock tune FA ratio .0694 which is 14.4 to 1 why is rich and not .0680 14.7 to 1?
Thanks.
Hello, I had the day off so I decided to log some Fuel Trim and Spark info. My vehicle is all stock, and when looking at the fuel trims and spark retard, I see that it is removing fuel where it is...
You need to review the post by 06300CSRT8 on PID controlled idle.
Thank you.
Hello,
I recently purchased HP Tuners for my 2010 Jeep SRT, as you know it comes with 8 Dodge credits. Since I am only using on my personal vehicle I have 6 extra credits. What I would like to...
I will check that. Thanks:)
Is there a way to check for the Readiness Codes for the emissions systems??
I was just reading through this thread to further my education. Looking at my tune, I do not see a switch for the NN, does my 2010 Jeep SRT have that option? If not do I need to worry about it...
Do you have a log of the hesitation when it occurs?