I have this in a customers car that I paid for, hope it helps you as a guide. if theres something wrong with the tune please let me know I?m still learning
Type: Posts; User: andresz28
I have this in a customers car that I paid for, hope it helps you as a guide. if theres something wrong with the tune please let me know I?m still learning
happened to me today from using the mpvi2 to the mpvi 1, and not even turning off the laptop helped, what I did was that I unplugged the mpvi from the car and the laptop and then reconected them . Or...
hello, today i read the pcm from a 2012 juke but when I open it gives me two messages:
1. validate checksum failed. You will be unable to save or flash this file. Controller:SH_7058
2. Definition...
I did that and the problem is still there... Ill have to check if it isnt something mechanical, fuel filters are new by the way
im telling you, the only times I have seen a map behave like that , is when you have a big vacuum leake, take the intake manifold out and recheck the orings, and install it again and test it, it is...
I already increased the smoke limit, but what i noticed is that when I accel it halfway it pulls harder than in wot, could it be the etc limit? but i didnt see that changed in the sct and midevil1...
I did that and it keeps doing the same thing,
thank you, i?ll do that
check your injectors data,there are a few things a lot different than they should be, and looking at you log you must look for a vaccum leak or something, it is at 90kpa at idle, it should be at 40s...
send me the tune you just did to check it out
so... any progress?
subscribed :secret:
hello, looking at your tune, first thing is at general put 5.3 instead of 4.8, you ve tables are super low... glad your timing is set to 8 or it would already blown, your torque management is not...
well not mine... thats why I made this thread...
nothing special besides creating your own pid or loading one, becuase the stock one only marks 105 kpa
yes but it says avoid steps 17-18 on 98 vehicles not 19 or something else... but thanks anyway ill look for that pid or make my own
after installing the 2 bar sd Os i tried to change the PIDs but it only shows me the stock ones and not the 2 bar option is on a 98 camaro pcm didnt have that problem on my 0411 please help
...
good morning, i searched but didn´t find a thing , just want to know if the sensor from summit PS10000 http://www.summitracing.com/dom/parts/dfp-ps10000/overview/ is the same as 09373269...
good afternoon , i have a problem with my pcm reading the map sensor after I installed the 3bar OS on it, it stays at 105 kpa and when i install the OS i was using before (1 bar stock) the map reads...
if somebody needs the 99OS with the 98 fuel gauge here it is remember is for the 9381344 OS
and what files are compatible with the 99 OS ?
i emailed bill all the files i read on this forum and he said all are incompatible.... does anybody have a 99 OS with the corrected fuel segment for the 98 fuel gauge to operate properly ?
the...
hello I did a 98 to 99 pcm swap and really need the fuel segment swap...
I hope you can tell me how to get them,identify them and modify my existing file (read somewhere i had to use hex...
thanks for the advices... i managed to fix it out.. the problem was bad fuel pressure... sometimes it was at 58psi sometimes at 20... ill just change the corvette fuel filter... thanks again
hello I´m Andres from El Salvador and I have a 67 firebird with an lq4 engine, im learning how to tune, it´s kind of difficult but all of you put great info so hope I can help someone soon