Search:

Type: Posts; User: wildkard

Search: Search took 0.00 seconds.

  1. I forgot all about this, but there is on either...

    I forgot all about this, but there is on either odd behavior. If I clear the dtcs with the engine running its dies instantly. Doesn?t matter if i I use hp or a stand alone code reader to do it. It...
  2. 2016 l83 swap pedal not working, hard starting

    I?ve got a buddy that has swapped a 2016 Silverado l83 into his square body truck. He ordered the harness from no setup for the vette pedal as it?s easier to mount but got impatient and hooked it up...
  3. Replies
    4
    Views
    3,174

    Ok, a little diag today since the weather has...

    Ok, a little diag today since the weather has cleared. Have full battery voltage in all 8 coils, that is between the hot wire and the ground wire at the coil connector.
    We decided to try an...
  4. Replies
    4
    Views
    3,174

    2017 l83 swap drivers side bank dead

    I have a friend who swapped a 17 l83 and 8l90e into a square body truck using a PSI harness. On initial startup it was missing pretty badly, and had a bunch of codes, mostly just things that were new...
  5. Replies
    8
    Views
    2,311

    Flash ram does have a limited number of...

    Flash ram does have a limited number of write/erase cycles, but you would be talking hundreds of thousands if not millions of cycles.
  6. Go to the system>fans tab, set the drop down for...

    Go to the system>fans tab, set the drop down for fan type to aux fans, and set the fan 1 on off temp to the speeds you want them at.

    As for wiring with the AC if you run a trinary switch instead...
  7. Replies
    3
    Views
    1,137

    Everything i have ever seen is that the TAC...

    Everything i have ever seen is that the TAC modules are complete black boxes, never heard of anyone making changes to them.
  8. Replies
    9
    Views
    11,354

    Thats kinda what I thought, but he isn't budging,...

    Thats kinda what I thought, but he isn't budging, nothing like a manual valve body or anything, just a crotchety stubborn ole bastard. I;m only doing the job because he's an old family friend. Will...
  9. Replies
    9
    Views
    11,354

    Eliminating PRNDL switch

    I have a guy I am setting up a wiring harness and tune for a lq4 with a TR224 cam and 4l60e that is adamant about not finding a selector switch for his transmission. Can I just turn the switch off in...
  10. It really is exactly what it says, it's the...

    It really is exactly what it says, it's the average amount of air the engine requires to maintain idle rpm. The computer uses it as a starting point for adaptive idle, which will vary spark advance...
  11. Replies
    27
    Views
    11,860

    Either missing or using mismatched parameters....

    Either missing or using mismatched parameters. The parameter you use in the histogram has to be the exact same one you are logging. For some of the parameters, manifold pressure especially there are...
  12. Looks more like bad power wire, the injectors are...

    Looks more like bad power wire, the injectors are grounded through the ecm to trigger them, the other side of the coil just goes straight to keyed power.
  13. Replies
    8
    Views
    2,766

    I had a similar problem with a 2004 6.0 and the...

    I had a similar problem with a 2004 6.0 and the similar p1514 code, I ended up just disabling the code and it fixed it, hoping that after i get the tune dialed in i can create a histogram for that...
  14. Replies
    10
    Views
    2,964

    SES needs to be checked, and it needs to be set...

    SES needs to be checked, and it needs to be set to MIL on first error or No MIL. In order to properly fall into speed density the MAF code must be set.
  15. Replies
    5
    Views
    1,686

    I used the stock table, just made all the cells...

    I used the stock table, just made all the cells between 140 and 230 1.00, only needed to change a handful of cells.
  16. 2003 6.0 dying after a minute so only when cold

    A friend of mine recently swapped a 6.0 out of a 2003 denali into his 67 camaro, stock heads and intake, with a mild (220ish duration) cam. I had just barely started tuning it when he decided that he...
  17. Replies
    6
    Views
    3,596

    6l90 to 4 speed swap

    I am helping a friend who is swapping a LSA from a cts-v into his 55 chevy, he has the engine, trans, computer and wiring harness. He has decided that he really doesn't want to deal with the headache...
  18. Replies
    3
    Views
    2,052

    Well crap, that's what i get for taking him at...

    Well crap, that's what i get for taking him at face value and not making sure he knew what he was talking about. It is a flex fuel, L59 with no flex fuel sensor, I'll have to get that disabled and...
  19. Replies
    3
    Views
    2,052

    5.3 swap weird stalling issue

    It's been a while since I did any tuning as I got my own swap running great, but a few weeks ago I did a harness and basic swap tune for a buddy putting a bone stock lm7 in his 63 chevy truck. Only...
  20. Replies
    5
    Views
    3,913

    The LC-2 has three outputs, a digital serial...

    The LC-2 has three outputs, a digital serial output for connection to the computer, this output is not configurable in LM programmer, it also has two analog outputs that are configurable, I left the...
  21. Replies
    5
    Views
    3,913

    Motor has stock injectors, and all I have done to...

    Motor has stock injectors, and all I have done to the tune is what I mentioned in the second post, the Rusk Idle scan though was done before I had the exhaust on, was surging pretty bad when in drive...
  22. Replies
    5
    Views
    3,913

    Ok, after the crazy weather here I was finally...

    Ok, after the crazy weather here I was finally able to get back to the shop and get the data off of my laptop. Here is the current tune the engine is running as well as a short idle log, during this...
  23. Replies
    5
    Views
    3,913

    Weird problem with wideband isntall

    I have a 5.3 from a 2003 truck I have installed in my Nova, lt headers and a moderate cam. I have installed a Innovate LC-2 wideband along side the drivers narrowband. I set the wb up to read through...
Results 1 to 23 of 23