Fixed it. Pin 8 on the MAF was wired wrong in my harness.
Type: Posts; User: vance580
Fixed it. Pin 8 on the MAF was wired wrong in my harness.
Looking for some help on a swap project I am trying to finalize. I am running and driving perfectly fine trying to get the tune finalized. I am getting 3 codes: P0097, P00F4, P2199. I have tested...
Anyone know what Unknown: 00 0A means in the predicted axle torque source means? I am trying to get my swap project going and when I hit the gas my truck goes then loses power at about 2k rpm and I...
Has anyone had a similar issue and fixed it?
Did you reflash with the MDI or HP Tuners? I am going to try the unlocked again using the MDI tomorrow.
I cannot get my truck to move when hitting the gas. I have a used T87A that is unlocked and was programmed by HP Tuners and I have also tried a fresh new blank T87A I programmed with an MDI. Neither...
Did you end up figuring out a solution to this? I have the same issue with a swap I'm doing and I've tried the suggestions in this post multiple times and nothing. Wanted to see if you figured it...
I'm using a E92 ECM and a T87A. I pulled the file from the ECM fine and just disabled VATS then did a write entire and wrote fine with no errors. Now I get no communication after I tried to link to...
I have just completed swapping a L83 (2018) into a 2019 Colorado. I am to software and I seem to have messed something up. I deleted VATS with HP Tuners and did a write entire with no issues. Then...