They may or may not physically have a look :D
Type: Posts; User: Overclock This
They may or may not physically have a look :D
Hi,
I have both P0420 and P0430 codes that are permanent. In the next couple of weeks I have to get my emissions test. I'm wondering how I can get these cleared. Currently my 2011 CTSV doesn't...
Good Call. I'll clean it up and see what that does. It can't hurt.
Thank you
I wasn't able to attach the original file that I wanted to, but I was able to attach this one which the STFT Bank 1 dies out at around 4:24
Hi guys,
I just hooked up a wideband to my 11 CTSV and I'm getting a random issue where STFT Bank 1 goes to 0 and stays there. In this specific log; you'll notice that it started off okay, but at...
I just took a quick look at your log. I think that you should get injectors in there ASAP before you throw more timing at it and go further
Nevermind - I saw the thread that mentions that permanent errors aren't cleared.
Hi guys,
I've been a little lazy tuning this vehicle, but I have a 2011 CTS V that has primary cat delete with...
Can you run 8psi with your compression?
The LQ4 table you have is different than what I have & use, your table seems richer and that's why I didn't recognize it.
A current scan showing proper LTFT's and current KR as well as a current bin...
What MAF/Throttle body are you using?
Your fueling is way out of whack.
I assume this is with the 3.5L
I'd like to see what you'd do with a 3.6L Russ.
You're not the only one that has noticed this.
I've had this issue as well.
I'd love to see this tune.
I was thinking about playing with my Envoy.
[email protected]
Thanks!
I'll give that a try!
Thanks!
I'm wondering how to tell if an update is needed or if it's already done.
When I lookup my VIN using http://tis2web.service.gm.com/tis2web
It shows many shift updates etc...
because it's listed,...
I have the dead pedal problem on my G6 GTP (E67) PCM with any cal I flash except the stock one.
TTT, I'd like to know if anyone has tried this also
Are you running this SD or with a MAF?
If MAF, which one are you using?
I usually use metric as well.
In the "camaroTuneB" file that you posted doesn't apply this technique from what I see.
4th apply at 0 tps is 72km/h but the 3-4 shift is 50km/h and so on...
I'm...
Hey Russ,
Just a question...
How come you don't use your "1-2 mph higher than shift point" and 1-2 mph higher than your downshift point on the release?
I've seen you say this many times on...
email sent
Hey Dave,
I have one.
Did you want me to email it to you?
It may take a while before it goes on the repository
Try a full write.
It should work.
What truck do you have?
Please oh please hook me up.
I'm dying to see what a CTS file looks like.
I'm using .19 also.
Can anyone else view it?