Search:

Type: Posts; User: ASX29

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thanks SiriusC1024! I will look into that as well.

    Thanks SiriusC1024! I will look into that as well.
  2. After looking at the Temp Thresholds for the...

    After looking at the Temp Thresholds for the "Catalyst Protection" I am pretty sure this is what it may be. I have an aftermarket Stereo and it allows me to view OBDII engine parameters that I keep...
  3. I am still poking through the tune to see where...

    I am still poking through the tune to see where conditions are being met to enter OL/PE because I don't think its PE. I was leaning toward the CAT Overtemp because there really isnt much of a change...
  4. I totally agree that am literally on the...

    I totally agree that am literally on the threshold on that available power for stoich with the added drag. I really wanted a V-Nose trailer but had to settle on one without. Is there a way to add a...
  5. Hey Alvin, thank you for that input. I have heard...

    Hey Alvin, thank you for that input. I have heard that as well about the radiator. Just swapping in a new radiator solved the overheating up hills?
  6. Here are the tune files for the ECM and TCM....

    Here are the tune files for the ECM and TCM.
    136352
    136353
  7. Yukon Denali 6.2 Entering PE When Towing at Cruise and Temps Climb Thoughts?

    Hello,

    I have a 2010 Yukon XL Denali with the 6.2. It has always towed great with an open 18ft trailer and a Camaro getting around 12-13mpg on highway and temps were all normal. Recently I...
  8. I appreciate the info and advise everyone! Good...

    I appreciate the info and advise everyone! Good thing is I have options to try unlike other things I try to do.
  9. Sounds like I have a couple options. I did notice...

    Sounds like I have a couple options. I did notice when looking at an older 1999 5.3 tune file that I do not have the crank low res option in the system settings However, the 2002 L31 file did. I...
  10. With that said do I even need to license a 4x...

    With that said do I even need to license a 4x tune file or can I just change the crank to low res on the stock tune on for the P01 PCM?
  11. Or is that only possible with a 411 PCM?

    Or is that only possible with a 411 PCM?
  12. I thought I would be able to do a 'write entire'...

    I thought I would be able to do a 'write entire' of a 2002 Express 5.7 tune file. No?
  13. P01 PCM on SBC L31 Vortec Pros and Cons to running a 4x vs 24x Crank Reluctor OS

    I have a L31 Vortec that I was going to do a P01 PCM swap. I do have a spare 24x reluctor wheel sitting around that I could externally mount on the balancer as option 1 with the crank sensor mounted...
  14. Well you helped clear up the fact that I am not...

    Well you helped clear up the fact that I am not crazy! I thought about putting it on the dyno but then again its not practical to start a dyno pull at 1500rpm. I guess a loose stall to quickly flash...
  15. I know I feel like I am trying to fine tune such...

    I know I feel like I am trying to fine tune such a small window of fueling that doesn't matter to most on the street because you will never notice. However, drag racing is an easy way to exploit...
  16. Recommendations on when to enter PE with cams and stall converters.

    I have run into the this question myself a bunch of times on different vehicles I have owned. The stock tunes always seem delay the PE RPM and it seems that from a standstill with a stock calibration...
  17. Anyone have anything to test or try to rule out a...

    Anyone have anything to test or try to rule out a PCM or transmission issue? Does the stuck in 2nd gear mean its in limp mode by chance?
  18. Or I had a thought. I have a 2004 Yukon Denali....

    Or I had a thought. I have a 2004 Yukon Denali. Should I just take that PCM, do a seg swap to an 80 and run that? Then use the 2005 PCM with the 12606961 OS and since it already is setup for a 60e...
  19. P59 Controller Load Different OS & Segment Swap HELP Trans Not Working.

    Hello, I have a 2005 Tahoe PCM with OS: 12606961. I am going to have it control a LQ4/4l80e combo in a 68 C10 Pickup. I do know (after much research) that I can't perform a segment swap for the...
  20. Replies
    7
    Views
    5,243

    Anyway to edit the notes within the License...

    Anyway to edit the notes within the License Information?

    76764
  21. Replies
    10
    Views
    11,106

    I realize I am actually only 45 degrees off. If I...

    I realize I am actually only 45 degrees off. If I retarded the ignition timing -45 degrees in the tune do you think it will fire and run?
  22. Replies
    10
    Views
    11,106

    Ok, I think I was right unfortunately..... I...

    Ok, I think I was right unfortunately..... I installed the wheel the right direction. Just 180* off. FML... I made sense of my scope with a little better resolution. See Pic.
    74938

    I wish I...
  23. Replies
    10
    Views
    11,106

    I am not an expert with the scope just yet. But...

    I am not an expert with the scope just yet. But this is all I could come up with for the time being. Will try to get more familiar with it to see if I cant get the resolution better.
    74931
  24. Replies
    10
    Views
    11,106

    That is good info. I will have to put a scope and...

    That is good info. I will have to put a scope and see what I come up with. What would a crank relearn do? Say if its off a little bit.
  25. Replies
    10
    Views
    11,106

    I wish I would have taken a picture just for a...

    I wish I would have taken a picture just for a piece of mind. But I am about 99.999% sure I installed it just like the picture. I am about to buy a camera snake and see if I cant tell how its...
Results 1 to 25 of 29
Page 1 of 2 1 2