Call NGK Tech Support at 1-877-473-6767 extension #2
Type: Posts; User: gmto2nr
Call NGK Tech Support at 1-877-473-6767 extension #2
I had the smoke problem with my turbo, thought it might have been because I did not prime the turbo before firing.
Good old Cam Sensor relearn huh?
Ya I have heard of the resistor method, however if you have hp tuners there should be no need for this??? Set to no errors reported....
Could you take a picture?
This sounds correct, if you are not using a BCM then the vats will definitely enable as the ecu looks for it, not sure if you owill even beable to disable it without the BCM, you will have to ask...
Mine did the same thing, unfortunately you have to write lo speed on it and it will most likely work. Unfortunately I never found out why.
Besdides the fact that I work for NGK I hate my AEM, the NTK sensor response time is 136ms , the fastest that I know of in the industry.
If you need further support with this unit please call me as I work at NGK tech support and can help you trouble shoot it.
1-248-726-7107
Jason Norwood
Thanks and have a nice day
Yes I can verify that since I work for NGK/NTK I have seen multiple AFX kits set up in our dyno cells next to Horriba machines that are north of 15k and the AFX is within a tenth. AFX all the way,...
Hello Guys
The AFX kit harness is 12' long and the signal wire can be spliced depending on the type of connection and the length of the spliced wire, see AWG guage chart for this. Another...
Thanks bill I had it right the first time just didn't add a/c to the table!! fixed it. thanks for the help!!!!
Ok I will read that very carefully and erase all my wideband set up data and start over. I have to open the specific scanner file when logging right? I cannot just open a scan or the generic scanner...
here are the 2 screen shots that i think youll need if you need another please tell me what one you need. thanks for the help!
ok so i plug the wideband wire into the side going to the a/c press sens? or the wire going away from the sensor? and i can leave the socket plugged into the press sensor while logging? sorry so...
Also could I email you a few screen shots showing how I have it on hp tuners? It says that my files are too big to post here. thx.
Thanks for the help, so I have to cut the wire completely and use disconnects to either connect the a/c or wb? Also do I leave the plug connected into the ac press sensor while logging with the sig...
Hello
Got my hp tuners tuning file up and running but can't get my aem to show a reading on the guage in the guages set up or log on the chart display. Must be something with my pid? I have...
Well tonite it worked no rhyme or reason.
currently working on this via email will post resolution when Bill and I figure it out.
So today I put in my bigger injectors for the turbo build and modded the inj constant as seen below, started the car and it was tryin to idle higher than norm at like 1k and bouncin to like 1200 and...
figured out. Had to do a read entire to license the car i was trying to add a license with a saved file on the desktop. didn't work.
Trying to license my car and hp tuners says I have 2 credits avail that i just bought and when I hit " show license options " it says " get credit information failed :0 . Any suggestions???
...
searched for a hour or so how do i do this? trying to request help and needed screen shots.
thanks
just hooked mine up .
use white wire for hp tuners and leave blue wire alone aem told me its for a serial out put.
hope that helps