Search:

Type: Posts; User: duster360

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    2,654

    Its going to be a tight squeeze into that Fiat. ...

    Its going to be a tight squeeze into that Fiat.
    The Pentastar is WIDE. Wider, valve cover to valve cover and just as tall as a Mopar 440 Big block. It doesnt look like even the Fiat 4cly has much...
  2. I have several JK tunes but most all are autos....

    I have several JK tunes but most all are autos.
    I do have a 2013 Manual from my 72 Dart Swinger's PCM

    From what I can tell, the JK Manuals don't differ much at all from the JK Autos

    128476

    ...
  3. Not a huge issue but you should increase the O2...

    Not a huge issue but you should increase the O2 Transport delay since the O2 sensors are a further distance from the Heads and A/F at WOT will thypically shift Lean a bit. Stock tunes tend to run a...
  4. Replies
    57
    Views
    63,672

    The phaser Lock pin is a physical pin that quite...

    The phaser Lock pin is a physical pin that quite literally locks the phaser together, thus disabling it until the PCM decides to turn "on" the VVT(starting, too cold, idle, ect).

    Here's an...
  5. Its basically a stock 5.7l 6speed tune. So...

    Its basically a stock 5.7l 6speed tune. So nothing particularly interesting.

    Since you're using low octane 91, to perfect WOT, you should be datalogging Long Term and Short Term Knock retard. The...
  6. This may be too obvious but id suggest believing...

    This may be too obvious but id suggest believing Bosch over "five0"

    Any sort of symmetry in spray pattern relative to the two intake ports would an improvement over what you have now.

    The...
  7. As you know, WOT is the easy bit and not really...

    As you know, WOT is the easy bit and not really your stated problem.

    As Greg pointed out, when the one side of the port & one valve is getting far more fuel than the other, erratic wall wetting at...
  8. let me know what you'd need ...

    let me know what you'd need

    https://www.needlesstorque.com/shop/p/full-custom-tune-for-pentastar-v6-car-ram-or-jeep
  9. Replies
    7
    Views
    2,654

    Lets see that Fiat?

    Lets see that Fiat?
  10. Replies
    7
    Views
    2,654

    I own the orange 72 Swinger 3.6L....

    I own the orange 72 Swinger 3.6L.
    https://www.forabodiesonly.com/mopar/threads/72-dart-swinger-3-6l-pentastar-t5.361683/


    Are you calling the TIPM(totally integrated Power Module) an SSR(solid...
  11. I'd leave it Long runner until a couple hundred...

    I'd leave it Long runner until a couple hundred RPM before full boost.

    During the spool, the extra torque is still needed unless you already have traction issues during that time.
  12. Replies
    1
    Views
    865

    There's no single % change that will ever make...

    There's no single % change that will ever make 2200cc work at idle, cruise and WOT and also work for pump gas and E85.
    General rule of thumb, once you get past ~+40% over stock, that "method" will...
  13. Replies
    6
    Views
    1,890

    The Trans input shafts can take a beating if...

    The Trans input shafts can take a beating if fully locked up clutch.

    You should have no issue getting a fast and firm shift with letting the TCC flash OFF/ON for a few ms
  14. Leave them alone X1000 That table is for...

    Leave them alone X1000

    That table is for characterizing the valve body solenoid's unique pressure profile.
    Unless you're trying to retrofit entirely different make/model/size solenoids onto the...
  15. Replies
    1
    Views
    731

    I charge $400 for just the Engine $600 for...

    I charge $400 for just the Engine
    $600 for Engine + Trans

    https://www.needlesstorque.com/shop/p/full-custom-tune-for-chrysler-v8-car-truck

    All my trans tunes are setup for higher/firmer...
  16. Nice work. This will be helpful. Interestingly...

    Nice work. This will be helpful.

    Interestingly that this issue doesn't exist with DiabloSport and SCT.
  17. Replies
    10
    Views
    2,480

    When does it want to shift versus when You want...

    When does it want to shift versus when You want it to shift?

    NOTE: Because of 1st gear's crazy 4.71:1 gear ratio that spins the engine so fast, its takes more time for the trans to make a decent...
  18. I've only ever got Aricharge to work on the 2015...

    I've only ever got Aricharge to work on the 2015 and 2016 that I tried it on.
  19. Replies
    12
    Views
    2,388

    This TCI 8HP70 converter I'm using should be...

    This TCI 8HP70 converter I'm using should be available soon.

    https://www.tciauto.com/triple-disc-bolt-together-8hp70-torque-converter-for-dodge-gen-iii-hemi-engines-3700-3900-rpm-stall.html
    ...
  20. I would have installed a cam long, long before a...

    I would have installed a cam long, long before a "dyno tune"

    Then 4000rpm stall seems ridiculously high for a stock cammed 6.1.
  21. 119097 These are the gains I got going from a...

    119097

    These are the gains I got going from a Comp S3 HRT cam + Stock converter(~1800) vs TCI 3700stall. It was dramatic change.(2016 5.7)

    Video at the staring line showed car launch ok but the...
  22. Replies
    7
    Views
    1,572

    Depends if idle was under 5-10% with the Cam but...

    Depends if idle was under 5-10% with the Cam but BEFORE you installed the injectors. Cams ruin VE under 2K and jack up the Fuel Trims, but so does a screwed up Fuel Model(aka injector scale)

    If...
  23. Replies
    12
    Views
    2,388

    Same in a 8HP Works fine even on a Stock tune....

    Same in a 8HP
    Works fine even on a Stock tune. Stock TCM tune isn't recommended but I ran it initially without any issues
  24. Replies
    12
    Views
    2,388

    How long was that tune working normally with the...

    How long was that tune working normally with the stock convertor?

    Exactly what codes are you getting?
  25. Replies
    1
    Views
    687

    Yes. It comes from the PCM's Torque Model. I...

    Yes. It comes from the PCM's Torque Model.
    I have my stock 2018 5.7 showing it making "500hp" lol
Results 1 to 25 of 141
Page 1 of 6 1 2 3 4