Search:

Updated with tune and datalog

Hey all, finished this cam install and engine is running good other than these issues:

*Throttle is erratic and running off at 32% throttle and speed over 30. I have been modifying the Driver...

Hey all, finished this cam install and engine is running good other than these issues:

*Throttle is erratic and running off at 32% throttle andf speed over 30. I have been modifying the Driver...

Good idea. I have done a idle relearn but it can't hurt to try again!

Excellent question, yes 3/8(if I'm not mistaken that's what the tech data says)

Posting a tune file isint a problem. Just curious if anyone else has seen this with the symptoms being laid out.

Thanks!..the gadget is good and fulcrum flex drive is ops checked as well.....meanwhile, nothing out of the ordinary on data logs. Again, if I put it in speed density mode it's fine till it's...

Hello all,
I have a weird issue upon installation of an MSD Air Force intake onto a 2013 LS7, what's weird is the car starts and dies immediately unless I put it into speed density mode and then...

HELLO!,..Got the idle fixed(thnx hemituna),..however, has anyone see a reason the car would go to limp mode at idle?...I think its something to do with the Hellcat throttle installed.

Also is the...

Hello everyone, I see you are folks knowledgeable on the Dodge side(I am a GM guy). I am helping tune a 2019 Charger with a maggie 2350 and running into a little issue when I give it throttle it...

plugs are good,..there is no throttle response once running,....it could be map..just trying to narrow down either map, ground or tune.

Trying to figure out why C7 Z06 will start then die. fuel pressure is showing 77psi at power on at low side...any ideas(tune loaded) just making sure its not a tune issue, ground or power issue, as...

got it ,..shot you a PM!

OK Folks!

*I have set up the car for SD tuning and utilizing VVE-(virtual VE).
*I have changed the settings for the injectors from the data at FIC and lowered IPW and Short PW adder to...

Thankyou!

Copy that..I will update the open side with same info.

I did,..didnt affect idle,..right now at idle point manifold is closed and that is the information being modified. im looking for the PID to identify when manifold switch is open

That makes sense...! I assume then I tune normally?

👍

Hello!,..Need a bit of assistance on scaling for 1000cc injectors on this build..I have pulled the directions/data for these injectors, however it ony allows for a certain amount of scaling on the...

"If I get a moment I’ll look, but I’m guessing stock TQ model which it’s basically a stock Lt1 with less timing at that point hence the numbers"

Thanks man, let me know asap.:)

Excellent!...my guess it's something simple...thanks brother!

Hello folks, been tuning this GS for a few and stumped!, It runs excellent but not much more power (mustang dyno and showing 338/340tq at the wheel UPT TO 6100RPM),..a couple things:



*1 thing...

Having some issues after this cam swap.

Car Runs, but is throwing these codes, I installed a TSP cam and Cam phazer limiter, and port and polish of the heads, also did the DOD delete as well. all...

I have all the AFM codes still and they are not showing in the latest HP tuners DTS list(for me to disable). We have a Dyno and I have tuned Extensively on C7 and late model Camaros, However I have...

Anyone have a tune for a 2016 Camaro, just trying to iron out exactly what codes to delete.

Much Appreciated