hello to all
I'm just finishing my swap with this combo
I sorted out a/c compressor, PWM fans, VATS delete...
but I'm stuck with way too rish LTFT and even with MAF unplugged.
I think it is...
Type: Posts; User: Christian GM
hello to all
I'm just finishing my swap with this combo
I sorted out a/c compressor, PWM fans, VATS delete...
but I'm stuck with way too rish LTFT and even with MAF unplugged.
I think it is...
Hello guys
I have a camaro L99 with edelbrock SC, customer was not happy of power output so we went to BRT camshaft and LS3 conversion. drive the car around going around was going strong
I sent...
good morning,
I was able to add the proper calibration on one vehicle and test it.
well I have the very same problem. PTS setup again the B222A, the system is disabled.
looks crazy to me...
dear all,
since we're overseas we're not allowed to do it. MPV option is locked in Dealer connect. I always used aftermarket tool to fix spedometers
Now, we?re facing a problem. A huge problem....
103700
hello guys,
in a challenger R/T 6.4 there is a way to enable the 2 keys?
giving one the full power and to another half power for ealry driver?
let me know thank you!
with plugs out checked compression.. cyl 3 is down...
will start tearing down to see what happened soon!
I just ordered 6510 plugs, colder than stock 6.4 hemi...
let's give them a try
was a bad oil pressure sensor...
now I keep fighting with P0300 same condition...
HELLO GUYS
just 1000 miles on it.
at WOT, when it engages 4rd gear at 100 mph with hot oil it kepp trowing out P1524
it had 0W40 oil, I switched to 5W50 and it is a lot worse.
any experience to...
yeah... I suppose also a different bellhouse... the MY08 already has the 6 speed.
tnx
hello guys!
anyone has never swapped a 8 speed transmission into a 6.200 V8 Hummer H2, MY 2008?
it's the same powertrain of Silverado 4wd same MY...
it's not matter of costs, customer is aware of...
hello guys
do you plan to add support to tune Engine in 2019-2020 Jeep Renegade with
EYF-1.3L I4 Turbo MAir DI Engine w/ESS
let me know
thank you
best regards
or do you know some other...
it works!
thank you all
thank you both!
the car has long tube headers with high flow cat.
so emission is not an issue at all
I will play with some number on Thursday morning opefully!
bye
hello Guys
all Camaro (this one is AT8 with NPP) when start up at cold goes up a bit on RPM and makes a good loud engine noise.
if you add a Borla Exhaust it becomes a real loud exhaust and...
hello guys
I agree with all of you but anyway I need a 2018 /2019 Challenger 6.4 liters Edelbrock tune reading.
nobody has them to share?
thank you so much!
Was one bad spark plug. small crack on insulator.
strange that no missfire detected....
added log and tune file (by Edelbrock)
thank you
hello
I've just installed a Eforce 1598 into a stock 2012 Camaro with MANUAL transmission
if you keep the RPM above 2.000 it's all ok, nice to drive but the feeling is that not full power at WOT,...
hello guys,
I'm not skilled on diesel, more on petrol...
I see the tire size wizard is not there... how about properly adjust speedometer and tire size / transmission shift point?
all manually?
...
they're so bad?
hello guys
Edelbrock has not released the tune for MY 2019
I'm installing the EFORCE kit into a new Challenger A/T scat pack, 6.4 V8
someone has to share the STOCK Edelbrock tune file for MY 2018...
hello,
application is Corvette VIN G5602310, odometer is KM 86.076 I did the full service to it one week ago, with new carbon rotors in the front, front & rear brake pads, engine and differential...
yes I did... like I did always but looks like on this particular vehicle is not working.
maybe I should read also TCM and FPCM?
hello
nobody run into this issue?
thank you