Search:

Type: Posts; User: wrc

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Thread: Throttle Control

    by wrc
    Replies
    3
    Views
    1,857

    Throttle Control

    Hi,
    I have a 2017 Corvette 7speed, looking to adjust the throttle response. Looking at the tune and could not find it,
    is it adjustable?
    Thanks.
  2. Thread: Troubleshooting

    by wrc
    Replies
    0
    Views
    781

    Troubleshooting

    I recently noticed my Jeep SRT8 not running right, it has a hesitation off idle and runs a rough on acceleration, worse when cold. I scanned it and found the long term fuel trims for one bank was...
  3. Thread: VIN Change

    by wrc
    Replies
    3
    Views
    2,987

    VIN Change

    Is there anyway to change or rewrite the VIN for a module. I am trying to replace a failed component with a used part
    which has a different VIN.
  4. Replies
    8
    Views
    3,249

    I think you have to look at the Idle Torque...

    I think you have to look at the Idle Torque Throttle PID settings for drive, you should make some minor changes to compensate for the intermittent dipping. Try bringing in the adjustments a little...
  5. Thread: BCM Programing

    by wrc
    Replies
    6
    Views
    4,959

    Would you please expand on that, I do not...

    Would you please expand on that, I do not understand.
  6. Thread: BCM Programing

    by wrc
    Replies
    6
    Views
    4,959

    Thank you:)

    Thank you:)
  7. Replies
    24
    Views
    12,618

    In looking at the tune on my 2010 Jeep SRT ,...

    In looking at the tune on my 2010 Jeep SRT , current stock tune has Min @ 20kpa and Max @ 20kpa. In my Logs kpa never goes below 19kpa for any length of time, should I raise Min setting to say 23kpa...
  8. Thread: BCM Programing

    by wrc
    Replies
    6
    Views
    4,959

    BCM Programing

    I would like to know if we have any control over BCM controls. I am looking into adding Hands Free operation to my factory radio with a
    factory kit. It requires that the vehicle be taken to the...
  9. Thread: How to adjust DFCO

    by wrc
    Replies
    0
    Views
    1,385

    How to adjust DFCO

    ....
  10. Replies
    24
    Views
    12,618

    Just following this thread, question, is the...

    Just following this thread, question, is the proper way to adjust these settings to decrease all the rpm delay by 10% to start or just the lower rpm speeds?
  11. Replies
    41
    Views
    39,715

    Thank you for the information and instruction. ...

    Thank you for the information and instruction. Very helpful!
  12. Replies
    41
    Views
    39,715

    So that I might have a better understanding of...

    So that I might have a better understanding of how this control works. If a vehicle is over the desired speed, you would increase the negative side of the scale to increase the torque to close the...
  13. Replies
    41
    Views
    39,715

    Quick question with respect to the -1000 to +1000...

    Quick question with respect to the -1000 to +1000 scale on which side of zero is it adding rpm? Additionally if changes are made to that scale, for example reducing the ends from -+1000 to say...
  14. Thread: Reset Adapts?

    by wrc
    Replies
    2
    Views
    1,736

    The option is in Scanner under the Vehicle...

    The option is in Scanner under the Vehicle heading in Diagnostics and Info.
  15. Replies
    2
    Views
    2,320

    If I am correct I do not think the Diablo tune...

    If I am correct I do not think the Diablo tune makes any changes to the trans settings. What I would do, if you want, save the Diablo and stock tunes and use the compare feature. See what if any...
  16. Thread: FA Ratio

    by wrc
    Replies
    3
    Views
    1,977

    Will you also be changing the PE Ratio table?

    Will you also be changing the PE Ratio table?
  17. Thread: FA Ratio

    by wrc
    Replies
    3
    Views
    1,977

    FA Ratio

    I was looking at my stock tune FA ratio .0694 which is 14.4 to 1 why is rich and not .0680 14.7 to 1?
    Thanks.
  18. Replies
    0
    Views
    1,078

    Fuel Trim and Spark Retard

    Hello, I had the day off so I decided to log some Fuel Trim and Spark info. My vehicle is all stock, and when looking at the fuel trims and spark retard, I see that it is removing fuel where it is...
  19. Replies
    4
    Views
    5,301

    You need to review the post by 06300CSRT8 on PID...

    You need to review the post by 06300CSRT8 on PID controlled idle.
  20. Thread: Credit Question

    by wrc
    Replies
    2
    Views
    2,205

    Thank you.

    Thank you.
  21. Thread: Credit Question

    by wrc
    Replies
    2
    Views
    2,205

    Credit Question

    Hello,
    I recently purchased HP Tuners for my 2010 Jeep SRT, as you know it comes with 8 Dodge credits. Since I am only using on my personal vehicle I have 6 extra credits. What I would like to...
  22. Replies
    95
    Views
    188,550

    Sticky: I will check that. Thanks:)

    I will check that. Thanks:)
  23. Replies
    95
    Views
    188,550

    Sticky: Is there a way to check for the Readiness Codes...

    Is there a way to check for the Readiness Codes for the emissions systems??
  24. Replies
    43
    Views
    28,103

    I was just reading through this thread to further...

    I was just reading through this thread to further my education. Looking at my tune, I do not see a switch for the NN, does my 2010 Jeep SRT have that option? If not do I need to worry about it...
  25. Replies
    1
    Views
    1,389

    Do you have a log of the hesitation when it...

    Do you have a log of the hesitation when it occurs?
Results 1 to 25 of 96
Page 1 of 4 1 2 3 4