Please disregard this post!
Type: Posts; User: Hulk408
Please disregard this post!
This is 3 bar SD only tune on a 410 LQ9 forced induction F!C blower ID1300 flex fuel setup on a p59 PCM.
I am attempting to get my WOT part of my tune done. I have noticed that my spark advance table values are being exceeded. I went back to look at the injector data and the tune has not been scaled. I...
I am trying to figure out what is with the fuel at idle. I have a set of ID1300 injectors and I have verified that the data is correct. I have a larger cam with 19 degrees of overlap. When I start...
Well the weidband I have has a countdown on it. I wait for the count down to read zero which is about 20 secs a d then start the vehicle. It's the afx2 wideband.
No the commanded is .86 but the actual eq ratio stays at 1.0 so my error is 15% lean.
So quick question for you guys. After a cold start (letting the car sit overnight) I noticed that my car is running really lean. The commanded EQ rations starts out at .85 and raises as the ECT goes...
Ok. So initial results are promising I just reduced the cruise area by 5% and I saw the changed reflected in my data. So thanks for all the tips and help. Time to get this ve table dialed in.
So with out a wideband I couldn't tell the difference with it running either. Honestly the motor sounds and runs fine but looking at the data it's just rich right now.
Sanity check. My car was originally tuned in Los Angeles where the atmosphere pressure is lower meaning there is less air. I moved to florida and increased my displacement. Here the atmospheric...
I will waiting on some relays will finish the 93 this weekend and then e85 after I drop the gas tank again
I have kooks long tube headers with spintech exhaust no open headers
I'm not N/A I have a F1C procharger.
Yes that is what I was looking for, I just found it really odd that it was running so rich when the STFT were turned off. I know that when I go to adjust the rest of the table I am going to have to...
Thanks for the reply, I have a set of ID1300 injectors, with a return style system and a good size cam. (specs attached) I did what you said about turning on the STFT and it dropped back to commanded...
I was able to add all the cells information in didnt take that long. I have attached a log file. Its still running really rich at idle. Would there be be any additional tables that are adding fuel....
Wow thanks much appreciated.
That's what I have heard. I plan on trying to get my tables as dialed on with straight wide band only. I appreciate the advise thanks.
I do have flex fuel enabled, I just planned on doing the same tuning process when I switch over to E85. Have you seen any better tuning results using a wide band specifically or using fuel trims as...
Thanks for the reply. That makes sense to clear the fuel trims before I make any logs. I will try making the changes by half.
I am new to tuning, I upgraded the engine in my car, we bored it 40 over and bigger new pistons. The tune that was in the car was good, just needed some work for WOT. I am attempting to re...
I purchased an afx 2 wideband and I was able to get the VCM scanner to read the right lambda after calibration. However I am unable to use the sensor input in the histogram for EQ Ratio error. The...
I have 2004 Gto M6 with a 408 F1c procharger and ID1000s injectors on a 2 bar map looking for a local tuner in the Jacksonville FL area.
Hadn't had time to mess around with this lately but I did get it started after a little help. I didn't notice the injectors were not scaled down there was way too much fuel being dumped, that has...
I tried stepping on the gas pedal and it has t helped. And I am new to hp tuners I don't know what DTC's are sorry.