Search:

Something strange I measured today. I hooked up a noid light to the injector harness and disabled each cylinder one by one. I noticed the cylinder I disabled using the VCM scanner did not match the...

I also determined that cylinders 4, 5 and 7 are not firing when the problem is occurring. I did a compressor test on 3 and 5 to see if there was a difference and they were both almost exactly 150...

I did a pressure test today and found bunch of leaks. The intake manifold gasket seemed to be the worst offender. I sealed everything up and it drives better.

The car still goes off the scale...

I did an HD2 kit with most of the parts. I pretty much copied Matt Happels trans settings since he did the same kit to one of his 4L80Es.

I found a massive vacuum leak today. My old (not currently...

Where do you see that the trans pressure for low part throttle shifting is low? Do you have a file I could reference? The force motor looks to be about stock.

Thanks for the feedback. I'll run through the tune and make the changes you suggested.

I'll also try out some of these ideas and report back with what I find.

Or there is a vacuum leak somewhere that only occurs when the engine is heat soaked (also possibly from a thermal expansion difference that doesn't occur until certain parts of the motor have heated...

Okay I'll download the latest version and try again.

I was thinking if it could be an o2 sensor and I think it's unlikely because when I command closed loop my wideband also agrees that is running...

I confirmed that the fuel pressure is the same between both tests. At idle it's sitting right about 41 psi. I also opened up the fuel filter and it looks brand new.

I've also added two new tune...

After fixing the injector issue I still have the same problem. Attached is a log file of me driving the car around from a cold start. The second log file is driving it around after 20 minutes of...

Found an injector that was stuck open. I'm going to replace it and go from there. I might try out the heat soak table you mentioned also.

If the car has been sitting overnight I can get in, start it up and drive as long as I want without any issues. However, after it's reached operating temperature if I go to restart the car after it's...

Thanks I'll take a look at it.

There's nothing special. Just make sure you have a charged battery and don't mess with anything while it's reading. My MPVI1 takes about 5 mins to do a full read.

littleb5911 could you please send me your tune file?

That's strange. What is your swap? Let me know how it goes.

Attached is a 2015 automatic and a 2014 manual. If you don't mind me asking, what are your plans?

I have a 2015 focus automatic and I want to increase the RPM limit in P/N. Currently it won't go past 3500 RPM. I recorded a log of me stomping the throttle in park. The torque source changes from...

Could you upload your tune please?

Figured I'd follow up on this and see if anyone could help out. Thanks!

FYI, I had to use the Beta 4.7.X VCM to read my calibration.

Thanks, that would really help me out. It's the NA 2.0L non-ecoboost.

Bump

I have everything to do the swap! Just need the manual tune file. Any help would be greatly appreciated.

I'll be sure to share what I find out so more people can swap out the crappy DPS6...

Does anyone have a stock tune for a Focus S or SE with a manual transmission? I am entertaining the idea of doing an automatic to manual swap and want to compare the tune files. Thanks

Does anyone have a MK3 focus 2.0 S/SE manual transmission tune? I am considering doing a manual transmission swap and wanted to compare the two files to see if this might be possible without swapping...